kangertech 0.2 ohm atomizer not registering

Status
Not open for further replies.

newton927

Full Member
Jan 14, 2016
19
4
31
I have a kangertech kbox nano, and 0.2 ohm replacement coils (disposable atomizers) and, when I screw them on too tightly either it will register but after firing it will display 0.0ohm, or it won't register at all unless it's loose enough to, preventing the guard from being screwed on over it, so I'm wondering why they won't work? the only difference that is apparent between the atomizers is that the ones that came with the kit are labeled 5i and the replacements labeled 5k, I can't find anything online about this and a website said nano is supposed to fire 0.3 (what it reads when it does register) 0.5 (0.6) and 1.5 (1.6) all of my atomizers register a point above their resistance, which I believe is normal... what do I do?
 

Robert Cromwell

Moved On
ECF Veteran
Feb 16, 2015
14,009
65,472
elsewhere
What I am saying it that the Kbox Nano is only supposed to work with coils down to .3 ohms.
So it should not work at all with a .2 coil. By leaving it loose you are raising the resistance sometimes to where it will fire. This is not a good thing for the mod or the tank.

For the actual resistance of a blister pack coil to be off by .1 ohms is not unusual.
 
Status
Not open for further replies.

Users who are viewing this thread