KangerTech Subtank Mini Vent Question

[DeJay126]

I recently purchased an Eleaf iStick50w with a KangerTech Subtank Mini. I noticed that on the bottom of the Kanger you can adjust the air flow. I am currently using the biggest vent and am producing good vapor hits, although it is a bit noisy while vaping. The smaller vent I use, it seems like the more vapor I get and the less noise it makes while vaping. What are the pros/cons of using the large, medium, and small vent holes? Just trying to get the best vapor flavor out of my setup.

I am currently using the .05 sub ohm atomizer and I noticed on their website it says that the range is 15-30w. Does that mean that I should not increase the power on my iStick over 30w?

Thanks in advance for the help! New to the vaping scene, but I'm thoroughly enjoying my experience and want to make sure that I know as much as possible to continue to have a good vape experience.

 

[bwh79]

The larger intake holes will allow increased airflow and better cooling of the coils and vapor, generally these are used for low-resistance, high-wattage and direct "lung inhales." The smaller holes will restrict the airflow and provide less cooling; for this reason they are typically used with higher resistances, lower wattages, and a more cigarette-like "mouth-to-lung" inhaling technique. But in the end, it's all about personal preference. Play around with the different settings, and use whichever one gives you the most satisfaction.

 

[Sir2fyablyNutz]

hi @DeJay126. In my opinion the air holes are to adjust so that each individual can find a comfortable vape, rather than a one size fits all. I use the single larger hole. Going over the recommended wattage of a coil risks burning it up and the dreaded dry hit.

Enjoy the journey.

 

[DeJay126]

hi @DeJay126. In my opinion the air holes are to adjust so that each individual can find a comfortable vape, rather than a one size fits all. I use the single larger hole. Going over the recommended wattage of a coil risks burning it up and the dreaded dry hit.

Enjoy the journey.

Do I risk damaging my vaporizer by going over the recommended wattage?

 

[DeJay126]

The larger intake holes will allow increased airflow and better cooling of the coils and vapor, generally these are used for low-resistance, high-wattage and direct "lung inhales." The smaller holes will restrict the airflow and provide less cooling; for this reason they are typically used with higher resistances, lower wattages, and a more cigarette-like "mouth-to-lung" inhaling technique. But in the end, it's all about personal preference. Play around with the different settings, and use whichever one gives you the most satisfaction.

Thank you very much for that information!

 

[Sir2fyablyNutz]

Most likely you'll burn out the coil. Shouldn't hurt the mod.

Do I risk damaging my vaporizer by going over the recommended wattage?

 

[Lewis8297]

Hi, the air holes on the bottom are for the cooling of the coils and allowing the vapour into your lungs, the smaller holes, less air onto the coils thus producing a warmer vape. Medium you get a cooler vape and more vapour, and the largest hole, coolest vape and more vapour once again. The smallest air holes are for mostly mouth to lung inhales, as you would typically smoke a cigarette, the larger air holes are for direct lung inhales. As the coils state 15-30w this is just a recommendation. You can exceed 30w if you like but you are prone to dry out/burn your wick due to the intense heat of the coil and the rate that the wicks soak up juice. Hope I was of help!

 

[DeJay126]

Thank you all very much.

I'll just lump this question into the thread real quick. I was looking around for nicotine solutions and found a website called v-ecigs.com that sells 50/50 or whatever mix you want and it comes with whatever mg nicotine content you want. All that is needed is flavor. Is this a good alternative for making your own liquids or should I just make the liquid entirely myself? I'm not sure of the rules surrounding posting links, if that is not allowed I'll revise this comment.

 

[SleeZy]

Thank you all very much.

I'll just lump this question into the thread real quick. I was looking around for nicotine solutions and found a website called v-ecigs.com that sells 50/50 or whatever mix you want and it comes with whatever mg nicotine content you want. All that is needed is flavor. Is this a good alternative for making your own liquids or should I just make the liquid entirely myself? I'm not sure of the rules surrounding posting links, if that is not allowed I'll revise this comment.

It's a good start to learn DIY with premixed bases (i use it now even because i'm lazy) Because all you realy need to do is add the essence. You'll get abit less nicotine than stated though due you're diluting the mix. (50/50 12mg with say 10% essence will give u near 10-11mg nic total when its blended)

Once you get a full membership (5 posts required to get it) you can head over here and read/post your questions about DIY juice.

DIY E-Liquid | E-Cigarette Forum

 

[Lewis8297]

Thank you all very much.

I'll just lump this question into the thread real quick. I was looking around for nicotine solutions and found a website called v-ecigs.com that sells 50/50 or whatever mix you want and it comes with whatever mg nicotine content you want. All that is needed is flavor. Is this a good alternative for making your own liquids or should I just make the liquid entirely myself? I'm not sure of the rules surrounding posting links, if that is not allowed I'll revise this comment.

In regards to this, what I've found out is that you can get really good liquids for a cheap price. Only mix your own liquids if you have time and patience, I've been working on a blueberry custard myself for about 3 months and I'm still not satisfied. If money isn't an issue the go for it, you can get some serious rewards from making your own juice. Just be sure the make small batches first, 10-30ml and allow time to steep as many people are impatient.

 

[SleeZy]

In regards to this, what I've found out is that you can get really good liquids for a cheap price. Only mix your own liquids if you have time and patience, I've been working on a blueberry custard myself for about 3 months and I'm still not satisfied. If money isn't an issue the go for it, you can get some serious rewards from making your own juice. Just be sure the make small batches first, 10-30ml and allow time to steep as many people are impatient.

I would say this is only if you realy want to make your very own blend. There's great essences out there that only require to add 1 essence + steep and it's amazing. (I'm using germanflavors incase you're interested)

 

[Lewis8297]

I would say this is only if you realy want to make your very own blend. There's great essences out there that only require to add 1 essence + steep and it's amazing. (I'm using germanflavors incase you're interested)

Yes exactly, I've tried all of the blueberry custard flavours i can get shipped to the UK and they're mostly average. However I decided to take it upon myself to make a blueberry custard, I prefer to make the wole thing myself because, although I do use pre mixed bases when I'm feeling lazy!

 

[Grimwald]

You can also use unflavored...that's my favorite. To me unflavored tastes more like what I vaguely remember smoking to taste like. It's also incredibly cheap.

As for the subtank mini, the amount of air is totally a personal thing. I use mine with a 1.8 ohm coil on the rba base, with the small single air hole. I'm only vaping at 8 watts, so that shows you how versatile the subtank can be.

 

[dom qp]

I use mine with a 1.8 ohm coil on the rba base, with the small single air hole. I'm only vaping at 8 watts, so that shows you how versatile the subtank can be.

For sure! 0.5 @ 30W direct to lung, full airflow, full chucks checking in.

Do you know how it compares to a Nautilus @ 1.8?

 

[Grimwald]

For sure! 0.5 @ 30W direct to lung, full airflow, full chucks checking in.

Do you know how it compares to a Nautilus @ 1.8?

Never used a Nautilus. It is similar to a Kayfun (perhaps a little better) if that helps.