So I'm sure this topic has been covered here ad nauseam but I couldn't find the answer after a few minutes of searching so let's tackle it again shall we?
Background:
I got a kayfun 3.1 last week and have been using it exclusively ever since.
I have alway used silica wick but decided I wanted to give cotton a try.
Using 28g Kanthol I build a .7Ω dual coil setup [dual coil on my first switch to cotton, i know hubris of me]
I added the cotton, gave it a couple of primer drips before putting the chimney on then filled her up.
I am getting wicked bad gurgling
I'm not sure if it's caused by too much cotton or not enough.
Thoughts?
Here are pictures of the coil
Background:
I got a kayfun 3.1 last week and have been using it exclusively ever since.
I have alway used silica wick but decided I wanted to give cotton a try.
Using 28g Kanthol I build a .7Ω dual coil setup [dual coil on my first switch to cotton, i know hubris of me]
I added the cotton, gave it a couple of primer drips before putting the chimney on then filled her up.
I am getting wicked bad gurgling
I'm not sure if it's caused by too much cotton or not enough.
Thoughts?
Here are pictures of the coil