Bad center pin on KFLite+. Seems to be recessed, can't make connection (won't fire). Any help with this is much appreciated. Thank you!
Kayfun Lite Plus by Ivogo bad center pin
- Thread starter JuiceBugg
- Start date
- th_trl_thread_readers 0
- Status
I had same problem with 2 ivogo kfl's. first one from local vendor, second one from angelcigs, 
Last edited:
There are a couple of options. I got one like that from Tobeco. I used a tiny o-ring around the center pin to give me that little bit it needed to extrude. Another option is the complete overhaul kit from fatdaddyvapes, which comes with a new pin to try. Finally, you can remove the center pin and sand the 510 threading down a bit on the kayfun.
thx Tinkiegrrl. where did you find the o-ring at? i tried one i had on hand but it just squeezed out from the sides of the head of the pin. needs to be pretty hard i would think.
I wound up cutting a piece of an old Protank gasket. That rubber piece on the bottom of a protank coil? Also, you can get spacers from madvapes I believe.
Are you sure it's recessed. I thought the same thing with mine. Someone on here suggested using a straight edge to check and sure enough, it did extend past the 510 a tiny bit. I would have swore it was recessed. I ended up having to raise the pin on my MVP a tad.
yes it was recessed joesquid. thanks for the input though. while i was at work i made a nylon washer out of a big zip-tie. sanded it down to the right thickness, drilled out center for my post and fine tuned the edges with a razor knife. slapped a coil on that thing and it reads 1.5 on my mvp. woohoo!
Glad it worked out for ya.- Status
Similar threads
