kayfun mini clone ohms limit?

[VapourFrenzii]

just got a kayfun mini clone, was wondering if it could go to 0.80 ohms or if that would be to hot for the insulators? is it the same as regular kayfun clone? any and all help is appreciated

 

[retic1959]

just got a kayfun mini clone, was wondering if it could go to 0.80 ohms or if that would be to hot for the insulators? is it the same as regular kayfun clone? any and all help is appreciated

If you make sure your coil is well above the deck it's no problem but personally my sweet spot is 1.5-1.7ohms in a kayfun , they're flavor machines not fog machines , they're not really intended for subohm vaping , .8 is not a problem but not necessary IMO .

 

[MrPlink]

Getting it wick properly when you go super low can be a challenge. If you are set on running it that low you may want to open up the juice channels a bit (esp if you have a cheaper clone.)

also keep in mind too much heat and the positive deck insulator can melt and give you a short.

Also might wanna consider something made to run dual coils if you really want to run sub ohm, like a fogger v4

 

[coaldriller]

If you make sure your coil is well above the deck it's no problem but personally my sweet spot is 1.5-1.7ohms in a kayfun , they're flavor machines not fog machines , they're not really intended for subohm vaping , .8 is not a problem but not necessary IMO .

That's right....designed for flavor, not vapor..

 

[motabrownie]

If you make sure your coil is well above the deck it's no problem but personally my sweet spot is 1.5-1.7ohms in a kayfun , they're flavor machines not fog machines , they're not really intended for subohm vaping , .8 is not a problem but not necessary IMO .

This.

How are you liking the KFL mini? I was thinking about getting one but havent seen much feedback.