KFL clones are gettin so inexpensive
- Thread starter regal55
- Start date
- th_trl_thread_readers 0
- Status
I just ordered my EHPro Kayfun Lite plus v2 clone, $27.99 !!! Can not wait till this gets to me next week!
For me it's been hit or miss. I have two $14 Kayfun clones from FT that are fantastic. I have another all black one from FT that I thought would be the same manufacturer, but it's the worst of the fleet. The finish was terrible, and airflow through it was the worst out of the eight or so I have now, even after drilling it out to 2mm (which I do to all of them).
I had some success drilling out the center pin of my Tobecco KFL+ V2, so I may try that with that one as well.
I had some success drilling out the center pin of my Tobecco KFL+ V2, so I may try that with that one as well.
Did you check the obvious problem places?
1) Lower Grommet blocking Air Passage
2) Debris in Center Screw - usually plastic
Either will kill air flow and I have found Both - mainly Debris
Check the Base Center Bore on the bad one. It should be larger than the Center Screw all the way through and only reduced by the upper/lower grommets. This allows free air flow around the pin and into Both air holes in the center screw.
I checked the center pin for debris when I drilled the base, but admit my inspection didn't go much farther. I'll have to take it apart for another look.
I got my last KFL+ w/ bottom airflow control screw and included nano kit from FT for >$30, but was worth it for the improvements over my 1st clone. Too bad I ordered batteries with it. Took 2.5 months to get here. Fuuuu!
- Status
Similar threads
