Kidney Puncher Atty and Provari

[SoonerChris]

Ordered a 2ohm atty from Kidney Puncher and when trying to fire on my Provari I get an E1 error which means short circuit/shorted atomizer. However, it seems to work on eGo TWIST.

Any ideas what the issue may be? Did I get a bad atty?

 

[y cherry y]

What is the resistance at? Can you check it on your Provari?

 

[SoonerChris]

Resistance was 0.9 to 1ohm. Already talked to the guys. They are sending me a new atty.


Sent from my iPhone

 

[Spit]

Try not screwing it all the way flush, or when you screw it all the way down back it off just a smidgen and see if that helps keep backing it off. Could be shorting on a too tight of a connection.

 

[Jake67]

Check the VV setting on the provari. I have found that when my voltage is very high on the provari and the ohms are lower I get that E1. Lower the voltage and it works. Good luck.


Sent from my iPhone