Legacy mysteriously stopped working

Status
Not open for further replies.

elfstone

Ultra Member
ECF Veteran
Verified Member
Jan 15, 2012
2,601
3,018
OH
This one is a little odd, I think. My Legacy stopped working.

What?... What on Earth can "stop working" inside a Legacy??! That's my question, too...

It doesn't fire at all with any carto / atty.

Switch - measures ~0.03 Ohm across from the brass screw to the threads.

Body - measures 0 Ohm across

Top cap - measures ~0.02

With the top cap off, button depressed, there is a 4.1V read across the battery nipple and top threads.

With the cap on, there is a 0.8 V read across the brass springs and atty connector threads.

It doesn't compute... What can be the problem?!!!
 

CaSHMeRe

Vaping Master
ECF Veteran
Jun 12, 2008
7,938
214
USA
elfstone ...

brass springs? I assume you are talking about brass screws?

With that said -- When you are getting .8v via the adapter screw, is that with the button being pushed or not?

When you check voltage, hit the button, and tell me what the adapter is reading :)

Lastly - Have you tried taking a paperclip or toothpick to the center post on the atomizer/cartomizer trying to drop it down a bit?
 

elfstone

Ultra Member
ECF Veteran
Verified Member
Jan 15, 2012
2,601
3,018
OH
Sorry - springs = screws.

The 0.8 was with the button pressed. I don't understand anything, but now it vapes normally and measures 4.1 V - I randomly threw an extra washer in the switch and it works now. Doesn't make sense still - it has been working for about maybe 7 months with no issue what-so-ever, not even the slightest. (Yes, I did clean it several times along the way)
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread