Liquid coming out.. What an i doing wrong??

[CJ Garcia]

Hello guys, ever since I started going into the subohmn tanks I started experimenting liquid coming out to my mouth, at first I thought It was the first mod, but i went thru 3 subox mini, and now a joytech evic vt and I still getting liquid in my mouth, what am I doing wrong?? Also if I leave the mod with liquid on it it start leaking by itself... Please help this is getting annoying..


Thanks


Sent from my iPhone using Tapatalk

 

[Fit_Four_Life]

Hello guys, ever since I started going into the subohmn tanks I started experimenting liquid coming out to my mouth, at first I thought It was the first mod, but i went thru 3 subox mini, and now a joytech evic vt and I still getting liquid in my mouth, what am I doing wrong?? Also if I leave the mod with liquid on it it start leaking by itself... Please help this is getting annoying..


Thanks


Sent from my iPhone using Tapatalk

Are you using the RBA deck on the kanger subtank mini? If so it sounds like there is not enough wick material which is causing the coil chamber to flood.

 

[CJ Garcia]

Are you using the RBA deck on the kanger subtank mini? If so it sounds like there is not enough wick material which is causing the coil chamber to flood.

I gave up on the subox mini, but I'm using the default nickel coil on the evic vt and still.. Idk what's the problem


Sent from my iPhone using Tapatalk

 

[Fit_Four_Life]

What tank are you using?

 

[CJ Garcia]

What tank are you using?

The ego one mega that came with the evic vt


Sent from my iPhone using Tapatalk

 

[Fit_Four_Life]

Sorry I'm not familiar with that tank. Hopefully someone else who has experience with this set up can chime in. I thought you were talking about the kanger subtank mini. Good luck!

 

[CJ Garcia]

Sorry I'm not familiar with that tank. Hopefully someone else who has experience with this set up can chime in. I thought you were talking about the kanger subtank mini. Good luck!

Thanks bro, yeah with the subtank I had the same problem too


Sent from my iPhone using Tapatalk

 

[mattiem]

Just thinkin' out loud here but maybe you are drawing to hard for the amount of power being put to the topper causing liquid to be drawn into the wick/coil and not enough power to vaporize it.

 

[CJ Garcia]

Just thinkin' out loud here but maybe you are drawing to hard for the amount of power being put to the topper causing liquid to be drawn into the wick/coil and not enough power to vaporize it.

Never thought of that... But yeah it might be it... I'll try drawing a little less hard


Sent from my iPhone using Tapatalk

 

[crxess]

Vaping laying down?
Tipping the unit to high?
Drawing to hard?
Over filling? - yes it needs an air bubble
Temps to low?

Lots of reason for leaking/flooding - mostly user error.
When the problem follows from tank to tank you have to start figuring out what You are doing to cause it.

 

[raylee]

I have had the Kanger original first version sub ohm tank which I got when it first came out and than I got the mini on Xmas eve last year and till now I have not had a leak.
I only use them on and off and will clean them when I do not used them. When I want to used any of them I make sure I check all the O rings are facing the right directions and properly seated. I will check the coil screws and make sure the Rba is seated tight in the base on every refill. Hope this help.