liquidxpress at 5v and 6volts a WInner for sure !!

[capeangler]

Liquidxpress Team ,
liquidxpress is a 5v and 6 volt winner for sure !!!
I really think it is for a couple of reasons , I do not like to talk publically about other's product , but your liquid is just a tad thicker than the other's liquid ,, the extra thickness is key at 5v or 6 volts , because it does 4 things . 1) it holds up under higher heat , and does not burn , it vapes, 2) when dripping it stays in the atty and does not run through the atty ( even though the prodigy is a sealed unit , which means that the run through does not cause problems with the battery it is still a pain the .... when liquid runs right through. 3) you can drip more of your liquid I would say about 20 % more with out worry of flooding the atty(this is key at higher voltages). 4) another thing is you can pull a little harder bringing more air through the atty without getting liquid into your mouth. the added air helps keep the atty cooler . A lot of people are struggling at 5V and 6 volts DSE 901 Atty burning out ... I think it is because the liquid they are using , just can not keep the atty loaded and therefore the atty heats up and pops.

I was using other's liquid today and I was out on the golf course so I did not have the abilty to go back to yours ... after vaping 3 drags the atty was so hot I could not put the unit back in my pocket ( vapor was also weak ) , got home loaded it with liquidxpress and vaped away for 20 drags and the atty was cool as a cuccumber with massive amount of vaper.

Thanks for a great product !!!
Cape

 

[mindtwist69]

We actually came to much the same conclusion about some of our flavors, and we are trying to make some of the liquid thinner for the lower voltage devices, and leaving our current line for the higher power ones.

Rob

 

[capeangler]

We actually came to much the same conclusion about some of our flavors, and we are trying to make some of the liquid thinner for the lower voltage devices, and leaving our current line for the higher power ones.

Rob

Rob , I actually think that your current recipe is great at 3.7 volts, much more flavor and vapor than others, the only adjustment that I make is that I just do not load up the atty as much. when dripping in a dse 901 3.7 volt 3 to 4 drops when dripping in a dse 901 at 5Volts 5 to 7 drops. I only have expereince with DSE 901(s).
IMHO I would not change LOL

cape