Long overdue SB accessory overhaul

[ahmadrulz]

Been avoiding getting into this world of unknowns. But just about reached the point where I have to. Somehow managed to lose my pouch containing spare batteries, and some flavors for 6v vaping.

I'm currently on the SB at 6v, using standard 510 atties.

Its time to move on to the tanks maybe.

I need a solid, reliable atty & tank combo.

Since I'm at 6v, I do need a solid TH. I'm assuming that can be tackled by using a LR atty along with a high drain battery?

Re: cartomizers/ atties, how long do they last? Whichever you would recommend/ suggest?

Appreciate it guys.

 

[Draco]

To be honest. Right now Im using a DCT, 1.3 OHM resistance and its absolutely amazing at 6v, very warm, very hot, and with bobas bounty, if I widen one of the holes it feeds fairly consistant.

May want to look into a DCT, or a diffrent brand of tank and use Dual-Coils [punched or slotted, either works]

~Draco

 

[ahmadrulz]

Sounds good! I was under the impression the 1.5ohm might not fire at 6v.

Whats the difference between the punched & slotted DCs?

And, how long do these atties typically last you?

 

[Groundswell17]

yeah listen to him, the whole high drain battery idea is good if you just need a little more than a standard 3.7 volt bat. For me though, high drain's are good for about an hour then i want to throw them on the charger again. got a kick a few weeks ago, thats done it for me, much better and consistent. But,, thats at 10 watts, as high as it will go. if i start wanting more i'm gonna be stuck goin to high voltage