Looking for Short and Stubby Tank

[hottls]

Looking for a short, stubby tank to fit on a Dingo similar in size to the rba that is on the Dingo in the picture. I searched but couldn't find anything. Can anyone offer any suggestions?

 

[Baditude]

The shortest cartomizer to fit a cartotank would be like a 35mm Boge.

Both of the IBTanked 25mm diameter standard tank https://www.ibtanked.com/shop-tanks-carto/clear-tubes/25mm-clear-detail
and the
Valley View Vapes Triple V Luxury 4ml tanks Triple V Pyrex 4ml Premium Tank would fit the bill, both being one inch in diameter and height.

The IBTanked has stainless steel caps, the Triple V Luxury tank has anodized aluminum caps.

For significantly more money, you might be interested in a Phiniac http://phiniac.com/.
In addition to a regular sized tank, they occassionally make a "shorty" tank that is only 29 mm in height. I'm not aware what cartomizer will fit that, but they must be available or why would they offer that tank? From the Phiniac site: "The Phiniac Shorty (this tank is only offered on occasion or by special request.)"

Edit: It's possible that these mini-carto would fit the shorty Phiniac tanks:

http://www.smoktek.com/Mini-20-ohm-low-resistance-cartomizer_p_262.html

http://www.smoktek.com/ReJuvenator-Mini-17-ohm-low-resistance-cartomizer_p_237.html

I would contact Phiniac to find out what cartos they recommend for the shorty tank and if, or when, that tank might be offered again.
____

Basically any tank that uses a 35mm carto will fit the bill. There are higher end tanks such as this $80 Fluid Flask http://www.e-cigarette-forum.com/forum/tanks/374209-anyone-using-tank-fluid-flask.html#post8452572 and the Kir Fanis tanks from Avid Vapor (which are always out of stock) http://www.avidvaper.com/cartomizer-tanks/. Be prepared to spend upwards of $60 plus for these.

 

[hottls]

Baditude, thanks for all the suggestions! I own a Triple V Economy Sidewinder 4ml Pyrex Tank which I'm guessing has the same OD as the Triple V Pyrex 4ml Premium Tank. It's a thing of beauty but quite a bit wider than what I'm looking for to fit on something tiny like a Dingo.

I will look into the Phiniacs to see what the OD is on them and I hear you on the Kir Fanis stuff. I'm waiting to be put on a pre-order list for one of these "Prive-Special tank" by Kir Fanis - Gr-Modders

Thanks again, I appreciate it.

 

[Baditude]

Baditude, thanks for all the suggestions! I own a Triple V Economy Sidewinder 4ml Pyrex Tank which I'm guessing has the same OD as the Triple V Pyrex 4ml Premium Tank. It's a thing of beauty but quite a bit wider than what I'm looking for to fit on something tiny like a Dingo.

I am not familiar with the Dingo, and you didn't provide its diameter in your original post, so I had nothing but the picture to go on.

The 19mm diameter IBTanks are much slimmer than the other tanks that I listed. I use seven of these on my Provari and Altsmoke BB. It comes in a standard length that can use a standard Boge carto.



Comparison of the XL and standard IBTanked in 19mm diameter. IBTanks 19mm XL tanks.

 

[fourthrok]

How about this one http://www.vaporbeast.com/Smok_Tech_Mini_Tank_Polished_p/a17.htm It's a polypro tank...but pretty nice, I think. 19mm diameter. There's a pic of it on the far left (they hold 4ml approx and are about 34mm high.