LR 306 Airflow

[Dauslyn]

Just received my Cisco LR306 1.8ohm atty with drip tip. I have an eGo and have typically been using the LR510s with a drip tip.

My issue is that with the 306, there seems to be too much 'airflow' when I pull on it. The LR510s seems to give a really tight pull, which is great, but I can't seem to match that with the 306. Taste is okay, but lacking slightly in TH and vapour production. Any one else have this issue? I've heard a lot of great things about these atties but if I can't fix this, I may have to go back to the LR510.

 

[tj99959]

A simple #5 O ring can be your best friend. The more of the air slots at the connection the O-ring covers, the tighter the draw will be. Just move the O ring up and down a tiny bit with your thumb nail until you get the draw where you like it. That O ring will also work as a small drip well.

It's exactlly the same as what a drip shield does when you slide it up or down to adjust the draw.

 

[Dauslyn]

beautiful, I'll give it a shot. Thanks!