LR cartomizers

Status
Not open for further replies.

Rader2146

Ultra Member
ECF Veteran
Verified Member
Mar 11, 2012
1,197
1,033
Waco, TX
So a 1.5 ohm dual cloil on a kgo is bad?

No, kGo would fall into the "3.7 Volt mods" category with 4.2v off the charger and 3.7v nominal. Small analog "look-a-likes", eGo's, and similar clones are 3.4v nominal. That, along with small capacity, is mostly why the 1.5 DC's are not recommended. High amp draw and small batteries dont mix well. Although, I've read of success with >900mAh eGo batteries and 1.5ohm DC's due to the larger capacity.

I couldn't be happier with my kGo and 1.5DCT.
 
Last edited:

Rader2146

Ultra Member
ECF Veteran
Verified Member
Mar 11, 2012
1,197
1,033
Waco, TX
Great choice, I really enjoy mine. Although it will probably be retired or gifted when my BoxMods are complete. The ONLY complaint that I have is that I dont like to carry it in my pocket. Even with a standard length carto without tank. Too long for pocket comfort where a BoxMod is smaller than a pack of cigarettes, or smaller than even a BiC Lighter.
 

Bradder

Am I Chip or am I Dale?
Supporting Member
ECF Veteran
Verified Member
Jan 12, 2011
1,136
546
68
North Carolina, USA
What's the range of voltage that I should use these on? I think somebody should put more videos on youtube explaining this. (hint, hint)

If not a video at least some memory device like "Vapers vape vapor" or " each 100mah = one hour battery time."
 
Status
Not open for further replies.

Users who are viewing this thread