MadVapes Tube Mod Kit

[DuineAnaithnid]

I was looking to get this kit from MadVapes and I had a question.

What exactly comes in the kit? What else would I need to get to use this mod with an 18650 batt and 510 attys (besides the batteries and attys themselves, obviously)?

Thanks

 

[Mr.Self_Destruct]

I just read it. You would have to get a 510 atty connector (to screw your 510 atty into) and a 5A horn style switch, and figure out a positive contact.

madvapes website" data-source="" class="bbCodeBlock bbCodeBlock--expandable bbCodeBlock--quote js-expandWatch">

In the simplest configuration, you'll need to install a switch, connector and internal postitive contact inside the cap (for positive battery contact).

 

[DuineAnaithnid]

Would you recommend one with a hole or sealed? (I drip)

 

[Mr.Self_Destruct]

Would you recommend one with a hole or sealed? (I drip)

atty connector? sealed.

 

[DuineAnaithnid]

yes, the atty connector. Thanks for the help, looking forward to this.

 

[AttyPops]

FYI - I hand sanded (actually a router table with sander) a round plastic disc to fit inside. Then had a connector on the center of it for the positive "nub/button" on the battery to touch.

I also added an LED, MV has them often with a resistor too. I get the small ones - 3mm I think. Some even color cycle if you like that sort of thing. I just used a blue one (for the 14500 model). I assume you have things like soldering iron, lead free solder, epoxy.

Also, don't forget the charger for that battery of course!

 

[DuineAnaithnid]

Yeah, I have the solder (I have built guitars before, so I have gotten pretty good at soldering). Thanks for all the info.