Making old cartos last - final stage: dripping a carto (batt end)

Status
Not open for further replies.

renstyle

Super Member
ECF Veteran
Feb 8, 2011
613
265
Boone, Iowa
Well, I'm starting to run out of "clean" cartos, and the budget is busted for at least another 2 weeks, so have to survive with the set of once-cleaned cartos that I have left.

I've found that once the cartos have been used, they are VERY susceptable to burning, mainly because most top-fill techniques depend on capillary action, which if you don't wait a few mins/hours, the wick won't be "wet" enough to work.

So after burning 5 cartos out in the span of 2hrs, figured I'd try a variation on the "condom fill", some have used the batt end of their carto to "top them off". I have discovered this is a great way to get the last bit of life out of your carto.

Dripping 1-3 into the cart, then holding it horizontal for a few seconds is all you need to get a good 6-8 toots before you would consider re-dropping.

It works best if you let the drop start to "fall" from the dropper bottle with gravity only, don't squeeze unless you have to. If you touch the "half-drop" to the top of the carto's batt end, it will suck right into the wick and not pool on the top (which happened frequently for me when I allowed the full drop to fall from the bottle to the carto hole).

Sure it's a pain, and I'll only keep this up until I can get some new blank cartos, but thought I'd pass it along, since it's keeping me in the vape on the cheap! :)
 
Status
Not open for further replies.

Users who are viewing this thread