MAP TANK conversion to 901 atty

[puffpuffexplode]

I created a juice tank, from the COV map tank. I did not like the ce2 cartomizers so I pulled all that stuff out purchased some adapters 901 attys.... To change atty just pull it apart.

Tank holds 4ml does not leak
Fill with tiny hole drilled above atty using a 18 ga needle.

Drip tip covers hole so no leaks there at all.

I have vaped myself silly only tools I used was a small drill bit in the derlin top stopper...

Draw is not airy either.

Hope ya enjoy I am ... Explode.

I have found my Vap Nirvana.

 

[WillyB]

You really need to provide some real details for folks.

 

[puffpuffexplode]

You really need to provide some real details for folks.

1 purchase map tank or something like it..
2 pull ce2 stuff out..
3 take 1 ego adapter screw it into your provari or other mod leave it there.
4 take 2 510 adapters and one 901 adapter screw all the adapters together
5 tap adapters into bottom cap of map tank make sure the 901 adapter is just barely above the bottom cap.
6 push adapters and bottom cap into clear tub
7 take top cap with a sharp knife trim cap that will be sealing top of 901 atty only trim a little at a time
8 once top cap is trimmed attach to top of clear tank.
9. take a small drill bit the size of needle for filling ... without driptip in place drill slowly at a angle that will miss the atty and the top of the clear tube.
10 once drilled top cap.... take needle filled with liquid and add 4mls of your favorate liquid
11 replace trip tip it should push into the top of atty and seal the hole you just drilled for filling tank.
12 attach to provari or favorate mod and prime atty with juice and vape.....

I have another tank coming I will take pictures on the next tank.... step by step...

total build time 15 mins only tools needed was a small drill bit a knife and a small hammer....

easy as pie