Mesh RTA that will wick 100%VG?

[RavenTai]

Hello, for about 5 years now I have been running a Digiflavor Mesh pro rebuild-able dripper, 10MM wide stainless steel mesh at 0.15 ohm, I run 100% VG unflavored, make it at home for cheap. love everything about it except for dripping, dripping is annoying especially when driving. I drip because last time I was at this choice wicking 100% vg from a tank was unreliable.

Has that changed? recommendations for a tank that will wick 100% vg? bonus if it will take the 10mm stainless I have rolls of, or if I can at least get stainless mesh for it?

 

[Izan]

Hi,
Have you tried squonking?
It's just like dripping, but from the bottom.

Cheers
I

 

[Superuser187]

I never had any problem with wicking on my zeus x mesh or any other rta with 95% vg that i was vaping for some period and it was winter....

i say it was winter cause it really matters cause for example if its not very cold climate where u live in my opinion is not that much of a problem to vape full vg....i just had make my cotton superfluffy in winter low temperatures so it was nothing unusual...
If u think rtas are kinda tricky i guess as izan said then squonking is perfect for you

 

[vaper1960]

This topic is a bit out of my realm... but I do know you can easily add distilled water (say 5 %) to VG to thin it out. Hope that helps. It will also work in something like a RTA. A RDTA is another option. Have not tried "squonking" but many here say it's the way to go.

 

[vaper1960]

You didn't mention but is PG a specific issue with you (some people have an "allergic reaction" to it)? Myself, I'm fine with it up to a point where it just bothers my throat.