Well I gotta say the BuzzPro is one tuff PV and I was amazed time after time when I dropped it that it would fire right up with no damage.I think it has probably been dropped 50+ times since I have got it because I am rather clumsy.Yesterday when I was using it with a 2.5 ohm atty it seemed to be down in power so I thought the batts were low and changed them.When I vaped again it was the same so I got out my under load meter to check it out.On the lowest setting I got 2.7v under load and at the highest I got 4.5v under load which is down a good bit.I took the top cap off to check and clean it and found that from being dropped so many timed the batts broke the pcb free and it moves around so I figure this is the problem.So if your BP seems down in power and you dropped it see if your pcb is knocked loose.I sent an email to Notcigs to get it fixed and i'm gonna miss having VV while it's gone since all my other mods are fixed voltage and adjusted by changing batts.
Messed Up My BuzzPro
- Thread starter jkoppk
- Start date
- th_trl_thread_readers 0
- Status
Jkoppk,
Go here RMA form
fill out the form and send it in. a new PCB is about $35 and they will lovingly install it for you. Mabye it just needs to be reseated, and secured, they probably can't say for sure till they get it into their hands.
Go here RMA form
fill out the form and send it in. a new PCB is about $35 and they will lovingly install it for you. Mabye it just needs to be reseated, and secured, they probably can't say for sure till they get it into their hands.
I don't have a printer so i'm waiting for an email or message to see if I can copy the RMA to a sheet of paper and send it in.
What I did with my Infinity when it broke loose was took the batteries out, ran a little super glue bown there, turned it so the s glue would catch around except where the adjusting wheel is and it's been great ever since. Oh and I wiped out any excess with a paper towel.
Not me man, when something awful happens to my BP it'll be on it's way to Mike PRONTO! ......and I'll be the one sucking my thumb in the corner until it returns!!!
I'm too afraid I'd mess it up worse and void the warranty. Although I do enjoy reading about all your adventures fixing those BP/IP boo boo's.
I'm too afraid I'd mess it up worse and void the warranty. Although I do enjoy reading about all your adventures fixing those BP/IP boo boo's.
- Status
Similar threads
