So has anyone found a place that sells the silicon gaskets for the top and bottom positive post on the did clone?
My wick hole didn't line up with my pv so I gave it a 3/4 turn to align it. Apparently this caused me to wear them out over time and now the positive post "turns" if I'm not careful with the screw nuts. Now my wick hole is once again off center.
My wick hole didn't line up with my pv so I gave it a 3/4 turn to align it. Apparently this caused me to wear them out over time and now the positive post "turns" if I'm not careful with the screw nuts. Now my wick hole is once again off center.
Last edited:
