mod not firing with panasonic ncr18650 2900mah batteries

[bpark919]

Bought the batts from fasttech, and I'm running them on my EHpro ea Clone.

A nimbus with a sub-ohm setup (.3 ohm) and a AGA T-2 with a 1 ohm setup both will not fire. I charged them on my nitecore charger and it said they were full. Haven't load tested them yet but I was wondering if anyone could shed some light on the issue.

Thank you!

 

[Ryedan]

Are these the Panasonic NCR18650PD? I don't have that mod. Having said that, if those are the batts, I would look at a possible flat vs nipple top issue.

 

[TheSystemHasFailed]

It sounds like a throw issue, like stated above. I have the button top, then again I ordered them from Orbtronic...
Maybe even check the positive screw in the 510 (does yours have one?) that is what did it for me. No connection.