I'm rebuilding my mutation x v5. Now I haven't used it much, but when I first got it out worked great for about a month. Well I've cleaned it will, dried it, checked all contacts and screws, but when I put a coil on it, and fire it to get it adjusted, remove hot spots etc, after about 3-5 fires it will either read "no atomizer" or try to reset the ohms. I've tried it on a smok x cube 2, smok alien, and releaux 2/3, same on all 3 devices so I know it's not that. Anyone have any ideas?
RDA Mutation x v5 not reading after a about 4 fires
- Thread starter Cdrabun
- Start date
- th_trl_thread_readers 0
- Status
are you sure it's not the build? sounds like a build problem more then the RDA itself. you can check the 510 pin on the bottom and make sure it's all the way in and the insulator isn't damaged
The build I was attempting was a simple dual coil, 24ga kanthal, 6 wraps. I didn't see any damage to the insulator until I tried to take it apart then the thing shattered into 10 pieces. Any idea where they sell those online? That may have been the issue after all.
no idea. you can try fastech as they sell spare parts or contact the manufacturer. the bad insulator was the issue. glad you at least found it. sucks about your RDA though. hope u get it fixed soon
- Status
