MVP 2.0 with 2.5 atomizers??

[jclay1192]

So i got a pack of atomizers with a resistance of 2.5 ohms.. I stuck one in my PT2 and it wont fire on my MVP 2.0... i put it on my vamo v5 and check the ohms it reads 2.7.. is there a resistance that an MVP will not vape at??

 

[CommaHolly]

hum,,,,,,,,,you shouldn't have a problem with anything that high,,,,,,,

what does the MVP2 say when you push both buttons at the same time???

 

[Criticalmass]

The firing pin is probably pushed down. Pull out the pin a bit on the tank and see if that solves the issue.

 

[Shaybabe.15]

You shouldn't have any problems..It your battery charged all the way or is your atty in all the way? If anything the firing pin may be pushed down a little bit, pull it up a midge. Press down the two buttons P and U to see what it says. Maybe change the voltage/resistance and see if that makes a difference.

 

[LinnaSaid]

I agree, there's probably something physical going on with the connections, is the coil twisted tight onto the base of the tank? Is the tank itself not tight enough on the MvP? I found myself barely twisting on my tanks onto my egos but finding that with the mvp I have to make sure the tank tighter onto the battery. To test if you're getting a good connection press the two buttons to see if it reads the resistance.. If it says NON then the tank is not making a connection to the battery. I hope this helps somehow.


Sent from my iPhone using Tapatalk

 

[jclay1192]

it has to be the coil head.. i'll see if i can use some tweezers and nudge it out a smidge

 

[jclay1192]

fixed.. tweezers worked

 

[Baditude]

The MVP-1 had issues with the connector pin not making connections with some 510 connectors. Mine wouldn't connect with my Ikevape cartomizers in my cartotanks.

I could have pulled the center pin on the MVP, but it works fine with iClear 30 and Protanks which is what I use exclusively on the MVP.