MVP 2 issue

[PoeDung]

Hi,
Recently my mvp 2 has stopped reading the ohms on my devices. I have a trident v1 clone, igo-w v1, and a russian 91%. All these devices are reading 0.0 or non. I have tried cleaning the inside connector with a q-tip and napkin. Any other ideas on how to get this to work or what's going on with it? I have another MVP 2 and all the devices work fine with that one.
Thanks

 

[xtwosm0kesx]

Sounds like the connector pin inside the 510 has been slightly pushed down/is no longer making contact(not uncommon)try to GENTLY pry around the edge of the inside pin and lift it ever so slightly to restore proper contact.

Similar process to the ego battery fix of the same problem.

 

[Rat2chat2]

Yes the above video is what I was going to suggest. Good luck to you and I hope what xtwosm0kesx said helps you. If not I am sure someone will come along until you having it all figured out. That is what is so wonderful about ecf. Happy vaping.

 

[PoeDung]

That didn't help

 

[DasBluCig]

That didn't help

Does the "defective" MVP still fire, even though it can't "read" the resistance??
If so, it COULD just be a bad circuit board connection....BUT I wouldn't trust using it if I didn't know what resistance I was firing!!
Me.....I'd "retire" MVP #1.....and stick with #2.....
Oh.....and....maybe order #3, to replace #1!!
Good Luck!
Happy (vaping) Trails!

 

[PoeDung]

I think I got it. Had to pull up the center post on the mvp 2 a little harder and one of the O-rings came out, but seems to be working now.