my cloupir t8 isnt working..

[Preston L]

Out in charged batteries and it turns on, and shows them at 0%

 

[Topwater Elvis]

Have you checked the batteries with a voltage/multi meter?
What batteries are you using?
Have you cleaned the battery contact areas lately?
Tried a different set of batteries?

 

[edyle]

maybe the user is putting in the batteries the wrong way in the charger.

 

[Preston L]

...I am a student in CIT I understand what is positive and negative, vamped 2300MaH, 40amp reading around 3.7 Volts

 

[Preston L]

...I am a student in CIT I understand what is positive and negative, vamped 2300MaH, 40amp reading around 3.7 Volts

And literally, this has been of the shelf for 2-3 DAYS at most

 

[Topwater Elvis]

I'd contact the vendor you bought it from & ask for a refund or replacement.
Cloupor QC isn't the best.

Are you sure your charger is functioning correctly?
Fully charged batteries should be 4.2v ish
Have you tried a different set of batteries?

 

[Preston L]

I'd contact the vendor you bought it from & ask for a refund or replacement.
Cloupor QC isn't the best.

Are you sure your charger is functioning correctly?
Fully charged batteries should be 4.2v ish
Have you tried a different set of batteries?

I called them, no return policy of course, tried others, so I guess im stuck with this POS

 

[edyle]

...I am a student in CIT I understand what is positive and negative, vamped 2300MaH, 40amp reading around 3.7 Volts

What does 'reading around 3.7 volts' mean?

You said earlier "shows them at 0%"
Which I presume you mean the T8 device is showing them at 0% ?

So is the charger showing them at 3.7 volts?

 

[Preston L]

Do you not remember when I was asked to check on a VOLT METER. My t8 shows POWERED batteries as 0% but will sit there on for hours.

 

[edyle]

Do you not remember when I was asked to check on a VOLT METER. My t8 shows POWERED batteries as 0% but will sit there on for hours.

good luck.

 

[Topwater Elvis]

No reason to get snippy, your posts don't really make much sense and you seem hesitant to answer questions from folks trying to give assistance.
Around 3.7v isn't fully charged and you never mentioned what you're using to check battery voltage.

Are you sure your charger is functioning correctly?
What brand of charger is it?
Have you cleaned the battery contact areas lately?
Have you tried a different set of batteries?
Will it fire a delivery device even though the battery indicator reads 0%?

 

[Preston L]

Yes the charger works, the batteries work perfect in a flashlight. Contacts are perfect, tried different battery and same effect. And cloupor is designed not to fire if display is lower than 5%