My first dual coil build

[ChiBear85]

came out to 1.4ohms

 

[ChiBear85]

Not the prettiest but it's bursting out the flavor in my new Derringer

 

[Wraith504]

what is that like 13 wraps per coil?

 

[ChiBear85]

Yep exactly 13 wraps I'm still at 18mg nic so can't go much lower without being to harsh

 

[Wraith504]

what gauge is that and whats the inner diameter?

 

[ChiBear85]

It's 28g A1 3mm

 

[Wraith504]

Seems like it would have a bit of delay heating up...?

 

[ChiBear85]

I'll be going down to 12mg nic this month so that'll help me go a little lower like 1 ohm

 

[ChiBear85]

A little but not much really got it at 30 watts

 

[Ryedan]

came out to 1.4ohms

Looking good ChiBear . I don't know how high you have the coils from the deck, but I set mine up high enough to be in the air flow path.

 

[Ryedan]

A little but not much really got it at 30 watts

If you take a couple of wraps off the coils and go with a lower resistance, you should lose that heat up delay and the vape at the same 30 watts should not be harsher. In my experience, with regulated mods this is really all about the watts unless you go too far.

 

[Wraith504]

awesome congrats on kicking the sticks. You will probably find the lower your builds the less MG you will have to use.

 

[ChiBear85]

Thx not bad for my first dual was hard to get right though cause I had my contacts in when I did it need my contacts out when I build coils kinda fuzzy to me lol

 

[ChiBear85]

I got some twisted and triple twisted Kanthal ordered too will be here in a day or two I'd like to do them at like 1ohm

 

[ChiBear85]

It is killing the battery in my istick 50 though lmao

 

[justinlm24]

Not a bad first buid. Congrats man. Have fun with it! I'm new to building myself and have really started to enjoy it.

 

[ChiBear85]

Not my first build been building for about a month and a half in my lemo ll but it's my first dual coil build and first in an rda but thx I think it's ok for my first dual

 

[Asbestos4004]

Ya done good buddy. You can twist your own wire really easy. All you need is a drill and an Allen key! With .28, I usually twist it until it breaks off.

 

[ChiBear85]

I don't have any tools or I would but I got a good deal on the twisted 30 ft each for 6$ a piece

 

[Wolfenstark]

Well done ChiBear85
30 watts seems most of thats being required to heat that amount of wire up.