My First mod Eleaf istick 50w and Kayfun Lite RTA

[hyds]

I m a new vapor..!!
My first setup eleaf istick 50w and kayfun lite..!!
Need help to build a perfect coil
right now i m using Evod..!!!
Please help me

 

[Ovi Ghejan]

Here is where u wil found all the answers RiP Trippers - YouTube

'Remember Smoking is dead Vaping is the future and the future is NOW !'​

 

[spasmenokarabi]

Yeap. RiP Trippers videos are amazing. Also you can find a lot of different setup at youtube.
I personal prefer 28ga Kanthal A1, 7/8 ropes micro coil.

 

[Jim Beam]

Love his video's, he really good at coils.
I use orchid v4 and kayfun lite.
As of last night, I now have five of them lol.
Anyhow, I also use 28g wire in my kayfun.
Ten raps, 2.2 ohms and my battery seem to last.
Taiste is great and plenty of vape.
Im running .8ohms in my orchid.
So far, so good.
Love my kayfun lite, Im sure you will too.

Jim

 

[roxynoodle]

28g wire is a good start. When I had a Kayfun Lite, I liked a coil between 1.5-1.8 ohm. 8 wraps around a 3/32" or 2.5mm drill bit.

You want your wick touching the deck, but not blocking the juice channels. Fold each tail down and trim to the right length. Prime with e liquid and use a small screwdriver to push it into place behind the juice slots. Fire the mod to check for vapor. Screw on the chimney cylinder and look down it to make sure your wick is in place. Finish reassembling, fill leaving some air space, and enjoy.

 

[hyds]

Thank you so much guys...
RIP TRIPPERS

 

[hyds]

Finally i build my first coil on kayfun Lite....
With the help of 28 Awg kanthal A1 wire
and Japanese organic cotton...
my first build is 1.2 ohms

thank you so much guys...

 

[hyds]