My friends dad keeps coughing when trying to use his e-cig what can I do?
- Thread starter letmein
- Start date
- th_trl_thread_readers 0
- Status
1: tell him mouth-to-lung instead of direct to lung
2: aside from dropping nic he can drop watts
3: less vg in case wicking isn't keeping up.
4: try the tc
2: aside from dropping nic he can drop watts
3: less vg in case wicking isn't keeping up.
4: try the tc
Without spending any additional money.....
- try taking smaller puffs
- start drawing without the fire button pressed and then briefly press the fire button and continue drawing
- 'side draw' the drip tip where the lips are not air tight on the drip tip so your inhaling air and vape
- try 'mouth only' don't fully inhale
How long has the man been a smoker and how much was he smoking?
VG is thick/Heavy - Nothing like Smoke. NOT the Best choice to start out a LONG Term Smoker.
Subtank at 9wats is like Sucking liquid through a Straw - Raise to 14w minimum.
Reduce Air Flow for MTL vape.
Talk to him about Slow Easy Draws.
VG is thick/Heavy - Nothing like Smoke. NOT the Best choice to start out a LONG Term Smoker.
Subtank at 9wats is like Sucking liquid through a Straw - Raise to 14w minimum.
Reduce Air Flow for MTL vape.
Talk to him about Slow Easy Draws.
Yep and use a narrow bore drip tip instead of the wide one that comes with the STM.
Change to a 70/30 mix (PG/VG) with some nice tobacco flavour and sufficient nic. Start at 10-12 watt or so and bump it up if needed. Nice tight airflow for mtl.
VG takes getting used to for a well smoked throat... My dad also can't take high VG liquids whilst vaping for over a yr now.
VG takes getting used to for a well smoked throat... My dad also can't take high VG liquids whilst vaping for over a yr now.
The subtank always hits a bit too hard for me. I run the rba at 2.0 ohms and 8 watts, smallest air hole, and more narrow drip tip. It still pumps out more and harsher than other tanks...at least for me. Don't get me wrong, it's a good solid tank. However, I much prefer the Ego One (with the clr coil) for my vaping style.
So you might just try some other tank.
So you might just try some other tank.
You could also tell him to try the 0.5 ohm coil that came with it. I tried the higher one myself and found it to hit way too harsh. He will also need to raise his wattage to at least 15 watts. He may want a little higher. It also takes practice too. Also a sub-tank is not something I'd introduce to a new vapor. They hit a lot harder then the protanks and other regular tanks. I have found people who can hit them fine when new, but most tend to cough at first.
The inhalation technique is different from smoking. I had a lot of trouble my first week vaping while I adjusted. Long, light inhales, like a summer breeze.
I think the high vg might be a problem, too. If he's an older, long time smoker, a 50/50 juice would be better.
I think the high vg might be a problem, too. If he's an older, long time smoker, a 50/50 juice would be better.
Get rid of that 1.5 ohm coil the last time I got a pack of those it was the harshest coils I ever vaped, I have no idea what's going on with them. Put in the 1.2 ohm vertical coil. And run the lowest watts stamped on the coil. Or less.
TE="letmein, post: 17242477, member: 181207"]He is using high VG juice without flavour, 9 watts evic vtc mini, with a kanger subtank with 1,5 ohm occ coil.
Aside from reducing nic content, what do you suggest I do?[/QUOTE]
How does he draw from the tank? High Vg is thick, so MTL with the type of airflow on a Subank, can be too much. Even on the smallest airflow setting. I also suggest raising the watts for the same reason. 14-15w is a good start. Vg vaporizes at a slightly slower rate than Pg. If he can't tolerate higher watts, then he needs to use a thinner juice.
sorry about the messed up quote, my phone likes to mess those up.
Aside from reducing nic content, what do you suggest I do?[/QUOTE]
How does he draw from the tank? High Vg is thick, so MTL with the type of airflow on a Subank, can be too much. Even on the smallest airflow setting. I also suggest raising the watts for the same reason. 14-15w is a good start. Vg vaporizes at a slightly slower rate than Pg. If he can't tolerate higher watts, then he needs to use a thinner juice.
sorry about the messed up quote, my phone likes to mess those up.
^ This
Vaping has a different "feel" to the throat than smoking did.
We learned to smoke...now we learn to vape.
Tell him to not hit it like he did a cigarette...to use slower, more gentle draws
Every kangar product I've had as had coil resistance, wattage an mouth to lung. Direct hit on a little cardboard piece of paper explaining everything. It comes on the box, try reading it lol
Mine had 1.8 an 1.5 my first one from kanger. Was an awful device, you couldn't even go above 5 watts without coughing.
Like he said I'd suggest getting a 1.2 or going to a better manufacturer. Grips an curves are better an twenty quid cheaper
Like he said I'd suggest getting a 1.2 or going to a better manufacturer. Grips an curves are better an twenty quid cheaper
I applaud your enthusiasm, but Slow your roll...
Learn to use the device properly...FIRST.
Have a good time
I
It gets easier as one gets away from smoking. Also the initial catch in the throat doesn't get worse with use like smoking, could be just getting past that threshold.
Oddly enough, I wonder if flavor would avoid the need to hit it as hard, more sense of getting something earlier. Didn't say nic level, definitely an issue, some levels are just impossible. PG is known for throat hit but high VG pushes up the vaporization temperature so can also be too much. Also reduces wick power handling in a tank; more need to prime the coil and give it time.
The 1.5's on those are made for less power and vapor, but could just be bad. Don't have one...
Skold: best I can tell you're talking a completely different Kanger product, and maybe user error too.
Oddly enough, I wonder if flavor would avoid the need to hit it as hard, more sense of getting something earlier. Didn't say nic level, definitely an issue, some levels are just impossible. PG is known for throat hit but high VG pushes up the vaporization temperature so can also be too much. Also reduces wick power handling in a tank; more need to prime the coil and give it time.
The 1.5's on those are made for less power and vapor, but could just be bad. Don't have one...
Skold: best I can tell you're talking a completely different Kanger product, and maybe user error too.
- Status
Similar threads
- Locked
- Locked
