Nautilus to Atlantis

Status
Not open for further replies.

Blitzz

Senior Member
ECF Veteran
Dec 13, 2014
84
23
NH
Thinking about moving to the Aspire nautilus to atlantis and had some ?'s that I couldn't find.
Aspire Atlantis:
Also a "Which mod will be the best choice for a atlantis thread"

Better taste then nautilus?
Safe to use? (what to and not to do)
Cloud density?
Compatible with the evic supreme and if not what mod is the best to use? (I don't mind spending up to $100 - $200 if worth it)
Not to airy and mouth vape friendly?
Other comments or tips that you think is important to know or threads that would be helpful.
 
Last edited:

Phild0

Senior Member
ECF Veteran
Verified Member
Dec 14, 2014
99
60
Mesa, AZ
My opinion, Atlantis is a whole nother league than Nautalis. The Atlantis comes with sub ohm coils so you have to have a sub ohm rig to run it. Vapor out put and flavor, Nautalis doesn't even come close. I have 2 Nautalis tanks, and 2 Aerotanks that no longer get used since I got 2 Atlantis. I run one on a Ipv2 and one on a Segelei 100 plus. Absolutely amazing.

What to do: prime the wick when you get it, fill with juice and let it sit for 15 minutes to make sure the wick is saturated before you vape it. Also, remove the coil from the top and put it in the base to increase juice capacity. Make sure that the holes on the coil are lined up with the slots on the base for optimum juice flow.

What not to do; don't try to fire it with sub par batteries or a rig that is not capable of sub ohms. And don't drop it :)

i take lung hits, as mouth hits are uncomfortable for me, but I'm sure if you turn down the airflow, mouth hits would be fine. Open the airflow all the way and take as big a lung hit as you care to. It will seriously put out the vapor, and flavor.
 
Last edited:

pufZeppelin

Vaping Master
ECF Veteran
Jul 6, 2013
7,610
24,603
Florida, SW
Thinking about moving to the Aspire nautilus to atlantis and had some ?'s that I couldn't find.
Aspire Atlantis:

Better taste then nautilus?
Safe to use? (what to and not to do)
Cloud density?
Compatible with the evic supreme and if not what mod is the best to use? (I don't mind spending up to $100 - $200 if worth it)
Not to airy and mouth vape friendly?
Other comments or tips that you think is important to know or threads that would be helpful.

hello Blitzz, welcome to ECF

don't have, can't answer "Q" about the Aspires' - but have you seen this bad boy

it sure peek'd my interest - - a dual purpose device, looks pretty stout

- Kangertech Subtank Hybrid Tank

- https://www.youtube.com/watch?v=Ymg2QBtXCFY

Busardo has a good one, but it's an hour long :ohmy:
 

Rymesis

Full Member
Oct 27, 2014
53
11
Eastern Shore, MD
I had a Nautilus, thinking it would work for when I was out and not at home, it seriously lacked a lot to me after I was using even a modestly-priced clone dripper atty.
So, I ended up giving my nautilus to my room mate, and kept dripping until the Atlantis came out and heard people going nuts;
Decided to pick one up and give it a check, I burnt my first coil to a char on it(using 100% VG Cereal Killer juice
I went to lighter(60/40, 50/50) blends again and it's been fine, my second coil I got about two weeks of time on before I wanted to swap it out due to taste.
As it stands, it pretty much has replaced my Magma unless I want a hotter vape.
The Magma with Cereal Killer brings the milk out, so it literally tastes like a real mouth full of fruit loops to me
The Atlantis brings out more of the fruity vibes for me, for perspective, but both are much better than the Nautilus.

As far as mods go, I've tried the Magma on a friend's Sigelei 100w, at 30w and it was a hot and tasty, moreso than my mech mod.
On my mech mod(Hcigar Nemesis clone) it's pretty good
On the CF mod it's pretty good.

Note: I put in the Fatdaddyvapes upgraded contacts in my Nemesis clone
sanded down the button and used a scotchbrite pad until it was buttery smooth
put 3 17x10x1mm 50nm magnets in the switch and it -now- hits as well as the CFmod
before that the CF mod seemed to be a bit better of a vape to me though maybe it's cause I wanted another mod...

Well, if it helps you out at all, my local vape shop had a Atlantis atty set up to try with the CF mod and SubOhm battery for people that wanted to try them out, at least they did last time I was in.


EDIT: Oh...Minor pet peeve, I've never smelled the juice much out of any of the drippers I've tried or the 2 I've owned unless I put it in my face;
I can constantly smell my juice in the Atlantis, though YMMV.
 
Last edited:

Ridilen

Senior Member
ECF Veteran
Jun 14, 2014
94
74
Bolton Ontario Canada
I have been using a eVic Supreme for a while on Kangers and a Nautilus, and have recently started with a Hobo RDA.

The biggest problem i find is that you have to make sure the coils are above .5 Ohm. I have been making mine at about .7 Ohm and no problem. BTW when your battery is down to about 60-70% you might find it shuts off at >26W.

All in all, the Supreme has been working pretty good. But I am definitely going for a MOD in the future. Would like to get down to .2 Ohm at some point.
 

Hans Gruber

Full Member
Dec 17, 2014
9
4
I run an Atlantis on my EVic Supreme and found it to be very twitchy in variable wattage mode due to it trying to run at the upper limits of it's capabilities. The problem is with resistance drift in it's coil detection. One minute it thinks that the coil is .8 ohm and sets the voltage up to 4.5v but if the resistance drops over time, the device won't re-poll the coil and it'll go over 30w and shut down rather than dial back the voltage. Getting below 60% battery power for some reason exacerbates the problem.

For the Atlantis on the EVic Supreme I found that switching to Variable Voltage mode and setting it to 4.2 volts gives the most consistent and reliable "max power" vape out of the device.
 
Status
Not open for further replies.

Users who are viewing this thread