Need a simple suggestion on dripping atomizer please.

[Jay929]

I have read a lot on what I need and how to start dripping, but I am lost on the exact atomizer to use. I hear 510 or 306 atomizers are good to start with but when I am on sites such as Myvaporstore or fasttech I'm lost on what to get. I see a lot of detachable dripping atomizers and rebuildables. I would just like a standard atty to start with. A few suggestions on atomizers and sites to get them would be very much appreciated. Thank you.

 

[dgm76513]

Stormy's Vapor Cellar has the atomizers you are looking for. They're about a buck cheaper per unit than my local B&M.

Here is the link to a 510 low resistance dripping atomizer. If you decide not to purchase from there, it will give you a good idea what you are looking for.

Here are the 306 atomizers.

I would suggest the 510 as a good starting point as the 306's can be a bit finicky for beginners.

 

[Jay929]

Thank you! I just googled your suggestion because I couldnt load the image for some reason. Came up with this site Genuine Joye 510 Atomizer (Standard & LR) - VaporCast. Just to be certain, this is the correct one?

 

[Alyssasmama]

When I went to dripping I just had the vape shop set it up my rebuildable. Total cost was $8 for the wick wire and set up

 

[dgm76513]

Yep, that's the one!

 

[vapo jam]

i take it you're looking for something pre-made (not a rebuildable)? if you're willing to spend a few extra dollars, the HH357 atty's are considered some of the best available:

HH.357 Cisco Spec Hybrid 510 Atomizer - Avid Vaper

 

[The Ocelot]

Hi

I have a blog about the basics of direct dripping. You might find something useful in it Drip, Drip, Drip…

ETA: I use an LR306.

 

[Jay929]

i take it you're looking for something pre-made (not a rebuildable)? if you're willing to spend a few extra dollars, the HH357 atty's are considered some of the best available:

HH.357 Cisco Spec Hybrid 510 Atomizer - Avid Vaper

I was looking into this but wasn’t sure on the life of each and being that I have not tried dripping I decided to go with a basic model to start with.

Hi

I have a blog about the basics of direct dripping. You might find something useful in it Drip, Drip, Drip…

ETA: I use an LR306.

Your blog is actually what I was referring to when I stated that I read up on dripping.


Thanks for the help guys. Cant wait to start dripping.