Need Advice, Kanger Coil Ohms

[Miata GT]

I currently have a few T3Ss that I am using with an eGo 900mah battery. The T3Ss came with 1.8ohm coils which have been working out very nicely. Not knowing at the time that I had 1.8 coils a bought a 5-pack of 2.2ohm coils. I tried one and much prefer the 1.8's with this battery.

i am waiting for an eGo-v v3 vv/vw to come in the mail. I know with the adjustable voltage I can use the 2.2s with the new battery but I am wondering if I should ditch them for more 1.8s since I have had such good experience with them.

 

[Dakota Jim]

Don't ditch them, just use them once you get the VV/VW and just get the 1.8's until your new VV/VW comes in

and if you switch the 2.2 you are currently using out for a new 1.8 just keep the wick moist with some eliquid until you can use it again

Waste not want not

There are vapers in Nigeria that are using rusty barb wire for coils and you want throw WHAT away
(what my mother would of said)

 

[SmoKnoMoCigZ]

with the new vv battery you just need to dial in a little higher voltage for higher ohm coils and down a little for the 1.8 coils. both will work fine.

 

[Sthur]

Ditto wait for vv battery. Can also rebuild them later, don't throw away even after they are used.

 

[jffvera]

I find the 2.2's can actually be pretty nice with some juices that benefit from a little more heat, like Starfiblast or Bebblebrox from the Vapor Chef. Just hold onto them until you get your twist battery. Make sure you never get the 2.5s though, the twist probably won't be able to push enough voltage for them.

 

[jffvera]

Ditto wait for vv battery. Can also rebuild them later, don't throw away even after they are used.

Is that a Legend or evic in your avatar picture? I just ordered a legend on black friday and I am a little concerned about it, you know with the waving and vibrating and all.

 

[ZoltanZee]

Don't ditch them, just use them once you get the VV/VW and just get the 1.8's until your new VV/VW comes in

and if you switch the 2.2 you are currently using out for a new 1.8 just keep the wick moist with some eliquid until you can use it again

Waste not want not

There are vapers in Nigeria that are using rusty barb wire for coils and you want throw WHAT away
(what my mother would of said)

You are probably right about that,if you know any please hook me up so we can start a community, I have some kanthal wire to share too

 

[coalyard]

Good rule of thumb to start is +2 volts above the resistance of the coil, ie. 2.2 ohm coil, start at 4.2 volts.