need advices using ekowool and ribbon wire

[arar1971]

hello,
I received my 1.5mm,2.0mm,3.0mm ekowool and 0.4 and 0.3 kanthal ribbon and ss rope wick few days ago. I started to play with them to find right and best vape.I made coils for Vapeonly, did, RDA Octopus mini.first 3mm ekowool 2.1 ohms coil for Vapeonly but it was too thick and then I tried 2mm ekowool coil is better but at the end of the juice starts gugling 50/50vg pg with Vapeonly.Did atomizer ss rope wick and 0.4mm ribbon works perfect, nice vape good clear flavor.I recommend rope wick to everyone.on RDA octopus mini 3mm ekowool 3 turns 0.3mm ribbon, no burnt taste but ekowool kills flavor,and everybody says ekowool is better flavor than silica but for me kills flavor little bit,Am I wrong? So I need your advices,tips to make good coils for evod,protank,T3,vapeonly,Did or RDA,RBA any kind of atomizers.Now I'll try 1.5mm ekowool and ribbon on vivinovas too.
Thanks.

 

[c00lkatz]

The question you ask is very broad. You need to concentrate on getting one setup to work correctly and then take what you learned from that and move onto the next. Sounds like you're trying to do too much at once. The atomizers you list are all very different setups which have their own pros, cons, quirks and tips for coil and wick configuration.

 

[tmcase]

Ecowool....I've just started using this and I find that the flavor is way better than silica and it lasts alot longer. I've heard of people that go for a month with the same piece and just rewind new wire on it after cleaning it. If you torch the ends it will not fray as much and if you torch the whole piece it makes it a little sturdier to wrap your wire around. It's all I'm using now. It is also more absorbent than silica.