Need advise and suggestion.
- Thread starter MATVAPER
- Start date
- th_trl_thread_readers 0
- Status
Hopefully someone will pop in that can answer your question. just bumping you up since I have no experience with your set-up.
Your mod should have plenty of power for that tank. I have the iPV4, but not the tank. I hear it guzzles juice tough. It's designed to make huge clouds, so I would expect that.
Nope..drainig the juice..1 full tank will only last me for few hrs vaping at 25w.
You said you are using the RBA deck? What is your build? And what's the capacity on that tank?
How is your coil built? What type and gauge of wire? Diameter? Wraps? Ohms?
That tank is a guzzler if you think you going through juice now, kick it up to 100 watts with the quad coil you won't make it 30 minutes.
The higher the watts, the faster you drain juice.
If you want to wrap a lower power coil to drain less juice, use steam engine
Coil wrapping | Steam Engine | free vaping calculators
30 gauge
2 ohm
10 watts
If you want to wrap a lower power coil to drain less juice, use steam engine
Coil wrapping | Steam Engine | free vaping calculators
30 gauge
2 ohm
10 watts
- Status
Similar threads
- Locked
