Need help/info -- Vivi Nova 2.5 Wick

[Ginsu]

So im still trying to figure why this Vivi Nova 2.5 is just not vaping alot. I have my Vivi mini's and just vape just real fine. Here are some pics.

As you can see there's 5 wraps and when you fire it up only 4 wraps lights up. Is that normal. I also did a AO reading on my Provari 2 mini and it reads out 3.0 but the stamping on the atty shows 2.4 I do get a decent vape when i crank it up tp 4.4 - 4.5 Someone told if i the atty is set to 3.0 oHm set it to at least 4.5 to get a good vape. Not sure if it has anything to do with the juice i had in it, Halo CAFE MOCHA.

Thanks in advance

 

[Doogmar]

My 2.4 ohms heads are now reading at 2.9-3 ohms Your pic is what happens to mine. For the juice I have in mine 4.5v works pretty good. I notice I kinda go up and down on volts to see what vapes the way I want it. 4.5v @3ohms is 6.75 watts I tend to like to run mine somewhere between 6-8 watts.

If you have an iphone or equiv, theres a free app called Ohm's Law...I've been using that when I forgot where to go when I'm switching things. Also a chart: https://s3.amazonaws.com/data.tumblr.com/tumblr_m9dkanCt0I1qc8949o2_1280.png

I actually like running my 3ohm at about 4.7v = 7.4 watts

i've read some ppl like 10 watts, but it just burns for me.

 

[AttyPops]

Ya... if it's reading 3.0 ohms around 4.7 volts +/- to taste.

Ohms vary a bit. These things seem to have a wide QC tolerance, to put it nicely. VV helps.
Also make sure it's wicking OK. Tip and roll. Top rubber cap goes back on flat side down.

 

[Doogmar]

Yes swirl it, and tip it I find is the key, especially when the liquid gets low. I find myself doing it with my carto tank too, even though I don't have to