Need help with UD AGI

Status
Not open for further replies.

yoyoyo

Full Member
Sep 20, 2013
43
12
Mississauga
i got a rsst with 34g twisted kanthal 4 wraps at 1.5 ohms no hotspots on 10 sec drags hollow ss wick
everytime i change my wick and wire i duplicate my setup with good results ohms vary from 1.3 to 1.5

now my problem is from the start my ud agi, took me ten feet of kanthal and like 5 ss wire mesh to get a decent setup. which was 1.3 ohms, 34g twisted kanthal (the only gauge i got) hollow ss mesh. i already drilled the wick hole on the agi to match the rsst. this thing is frustrating me to the point that im about to lose it, been trying for 2 weeks to get a good setup going but for some reason the top coil from the post to the first top wrap keeps glowing red. ive been cleaning out and re wicking and wiring, taking out the juice blah blah, then when i burn it all the coils go red from top to bottom, i put the juice in and vape 4 to 6 secs its ok, i take a 10 sec vape and i get that metal taste, take out the cap and the top coil burns red.

My wick is saturated enough and even when i tilt it down to take a drag it just keeps glowing red, i vape on low volts like 3.2 to 3.4 even if i get a ok setup for a half tank the next day its the same problem :mad:, is it always going to be like this? all i can do is take 3 sec drags, exhale repeat 2 times and then wait 10 secs for the wick to cool down. soon as i take a 10 sec drag theres the burned metal taste and glowing red coil

my rsst doesnt give me problems, even with 100 10 sec drags with 2 sec in between it never gets that glowing top coil

somebody got any advice or a solution i can try?
 
Status
Not open for further replies.

Users who are viewing this thread