Need suggestions for RDA for original Mini..

[cadman]

I need some suggestions for a new rda for my original Mini.

I have been using Nuppins on my Grands and just got an Odin, just tried to use my Mini with a 3/32nd drilled RM2, aaaargh, not enough air flow....

What is available with good air flow and will still fit the juice well of the Mini?

Thanks in advance.....

 

[SteamStack]

I'm pretty sure a bud worx hornet will fit the original mini and prob the Era as well. Older attys though.

 

[Brew1961]

Hornet yes, ERA no but both are similar in air flow to the RM2. You can still find Hornets in the classies or buy a top-fed version from the Indy Vapor shop and have Chowder bottom-feed it. I just sent him an old TF Hornet and what came back was better then the original BF versions I have been using. He tuned those as well so all my Hornets shine. But they are not the Nuppin! Roberts planning to offer some LP Mini 1.0s in a few weeks or so and then you could use what you like just understand that the door only rises on a 15mm or smaller. Only one of my OG Minis has loose enough channels to let the door go up past an RM2.

 

[Brew1961]

The Chalice might be loose enough for you and it will fit the LP Minis. That's where I'm going to use mine. Damn near leak-proof as well. Brew

 

[keepsmiling]

Divo is another, if you can find one.

 

[Spydro]

I run a Hornet on my Mini OG. Neither the Chalice II or the III's will fit in it.

 

[davelog]

I used an A7 Mini on my OG Mini back when I had it. Bottom air, too, so you could blind squonk it. Vaped good but you gotta watch that wobbly center pin, the A7's (both sizes) are notorious short factories.

 

[cadman]

Thanks for all the replies and suggestions, doesn't seem to be any/many RDA's that have adjustable/large air flow and will still fit the Mini. I think I will try to drill multiple (3) holes on the coil side of the RM2 to see if it helps....

 

[cadman]

I used an A7 Mini on my OG Mini back when I had it. Bottom air, too, so you could blind squonk it. Vaped good but you gotta watch that wobbly center pin, the A7's (both sizes) are notorious short factories.

I bought a couple of the A7 Mini's when they first came out.... you are right about the center post..lol