Nemesis 18350 mode

[vicbreh]

Some questions i'd like to know from vape experts.. Using a 18350 AW IMR 18350 (red color) how long do these babies last for on a nemesis? Also what is a safe ohm reading using dual coils on an igo-w rda( im curretly getting .45 on 18650 mode) , thank you in advance? What batteries do you suggest on a Nemesis mech mod?


Sent from my iPhone using Tapatalk

 

[Scarey]

AW IMR's are great. For an 18350, don't go below 1Ω.

 

[jarreddizzle]

Depending on the battery you can go below 1 ohm; however, I would not go lower than 0.6 nor would I suggest or reccomend anyone to.

 

[vicbreh]

I'm hittin around .45 ohm with 1fold and 3wraps. On 18490. Is that bad or good? As for above is it dont go below? Or u can go below ? For 18350 batts


Sent from my iPhone using Tapatalk

 

[Rule62]

I wouldn't go below .8 ohms on an 18350 battery.

 

[vicbreh]

How can I increase my ohms then? Tia.


Sent from my iPhone using Tapatalk

 

[savagemann]

How can I increase my ohms then? Tia.


Sent from my iPhone using Tapatalk

You'll need to wrap a new coil with higher resistance.
You have 2 options.
Make a new coil with 1 more wrap, or make a new coil using the same number of wraps but larger in diameter.

 

[vicbreh]

I'm using 28g kanthal a1 should I get 32?


Sent from my iPhone using Tapatalk

 

[vicbreh]

1 wrap 4coils, Dual coil 28gauge 3mm silica wick hitting around .45 ohms on 18490 red aw IMR batt... Any suggestions what should I do to increase to a safer ohm ? Tia.


Sent from my iPhone using Tapatalk

 

[JMarca]

How long a 18350 battery would last is directly related to how much you vape and the resistance of your atomizer. Only you can really answer than but let's say you were a average vapor that takes a puff and puts in down for a few mins, I'd say 3-4 hours or so. You'd maybe go through 2 batteries a day.

 

[savagemann]

I'm using 28g kanthal a1 should I get 32?


Sent from my iPhone using Tapatalk

32ga would be a huge jump, depending what kind of resistance you are looking to achieve.
I like to play around with 29 and 30ga to fine tune if 28ga is not getting me where I want.
32ga would be good if you are looking to get into the ballpark of 2ohm or more per coil.
I would say if you were to only get one ga of wire, try 30ga.

 

[vicbreh]

Been on the tip with 28g will 30g bring it up a notch in my ohms? 28 been giving me .44 .53 around that area...


Sent from my iPhone using Tapatalk