new here | best simple cloud build?

[mattcc25]

so hey im new here ive been vaping for about 2-3 years now and have gone from the typical starter kits to mechanical's i was wondering dose any one have a simple cloud build and would feel free to share it with me

 

[steam heat]

We will need to have a lil more info from you as far as what atty you are using and what your skill level is when it comes to building coils..... But none the Less hello and welcome to the forum.

 

[mattcc25]

im looking for a build for my velocity on my parallel box mod with 2 sony vtc4's im fairly experienced with rebuilding and have built plenty of coils in the past and im just looking for some ideas for a new build haha and thanks for the welcome !

 

[SteveS45]

Welcome and enjoy your stay here!

I am sure you will receive some recommendations from the many experienced builders.

 

[steam heat]

I use 24g and 32g kanthal to make Clapton wire... 6 to 8 wraps around a 2.4mm bit...i use this build in a dual coil rda, it ohms out to be about .2/.3. Vape that with some max VG juice @ 100 watts or so and enjoy flavor and most of all clouds

 

[mattcc25]

ok sounds good i will give it a go thank you!

 

[Chips177]

I'm a huge fan of twisted and parallel builds on my mechs

 

[BrotherBob]

Welcome and glad you joined.

 

[suprtrkr]

I would use twists on a mech. Try triple 28s coiled to about .25.

 

[Vesuvius]

I have a Velocity clone. On my mech, I just run regular dual 24g Kanthal at .2 and it hits pretty good but twisted works very well on my mech.

Same atty on my RX200 is either twisted or parallel 24g at .2 anywhere from 50 to 100 watt and its throws some good clouds.

Always wicked with Rayon also.