New here with a mod problem!

Status
Not open for further replies.

MrsMikey08

New Member
Apr 5, 2017
2
0
44
Good evening all! I recently bought the sigelei fuchsia 213. Has been an awesome mod until tonight. Just started burning up the coil on its own. I wasn't even touching it. Also the button isn't sticking either. Couldn't get it to stop and my tank (uwell crown 2) was getting hot fast so I dropped the batteries out to shut it off. When I put the batteries back in and it powers up I get "fuc1624v1.1" on the screen for a while then it started firing on its own again! Anyone else had this happen?
 

BrotherBob

ECF Guru
ECF Veteran
Dec 24, 2014
14,108
12,444
Sunnyvale,CA,USA
Good evening all! I recently bought the sigelei fuchsia 213. Has been an awesome mod until tonight. Just started burning up the coil on its own. I wasn't even touching it. Also the button isn't sticking either. Couldn't get it to stop and my tank (uwell crown 2) was getting hot fast so I dropped the batteries out to shut it off. When I put the batteries back in and it powers up I get "fuc1624v1.1" on the screen for a while then it started firing on its own again! Anyone else had this happen?
Welcome and glad you joined. I would contact where I purchased it and Sigelei. I would want to go on record with the problem before my warranty lapses. If you do not, you might end up out of pocket at a later date.
 
Status
Not open for further replies.

Users who are viewing this thread