New Kayfun problem.

Status
Not open for further replies.

plumb4u2

Full Member
Verified Member
Jan 21, 2014
50
25
Forest Hill,MD USA
There are several variables. What mod are you using? On a mech, firing at 3.7v is 8 watts, which is fairly low. What's the pg/vg ratio of your juice? Higher pg juices will produce less vapor. All of that coupled with the Kayfun not being known for vapor production could be the problem.

Kayfun not being known for vapor production?? my kayfun blows massive clouds
 

joe sup

New Member
Feb 16, 2014
4
0
USA
If you build a 1.7 ohm and use it on a mech mod, it's normal since it will heat up very slow. I'm assuming you are probably using a vw mod hence the high ohmage. In that case, you might wanna increase your voltage to increase the potential. If you are using a mech mod, try sub-ohming. I build my kayfun .7-.8ohms micro cotton (6/5 wraps of 26 gauge). My personal opinion, 10/10 vapor 10/10 flavor in kayfun standards.
 
Status
Not open for further replies.

Users who are viewing this thread