New Magnetic Atomizer Connection Mod- by Eleaf

[Robert Cromwell]

Just finally watched the OP vid and it has an ego mag adapter to it would likely work nice with a T3S!

 

[drugarth]

why didn't they make it VW....? would make it so much better

 

[Bunnykiller]

hmmm somewhere, someone will design a magnetic attachment and get the poles backwards and then you would have to hold the atty on the mod to make it work...

 

[D. Waterhouse]

Lol, which one?

The bayonet fitting. I've been thinking about this for years!

 

[suprtrkr]

The bayonet fitting. I've been thinking about this for years!

Yup. Actually, they make 22mm bayonet fittings that would work: 225395-6: Connector BNC PL 50 Ohm Crimp Straight Cable Mount Gold: Amp/Tyco Electronics

 

[suprtrkr]

hmmm somewhere, someone will design a magnetic attachment and get the poles backwards and then you would have to hold the atty on the mod to make it work...

"If a thing can be done two ways, and one of them is wrong, it will be done the wrong way."

 

[EBates]

Think I'll pass on this one.

 

[Robert Cromwell]

Actually if the magnet adapter works well it is a great idea for down in a hole like that.

 

[Ryedan]

Depending on how good a connection this makes between the mod and the atomizer this might be something that will be the future of vaping...........

I feel better screwing my atomizers down tite and not be held in my a magnet but we will see............

Thanks for posting this trucker

It's a neat idea and could be great if it's well designed.

 

[papergoblin]

The only thing I see and someone may have beat me to it is, if a magnet reverses polarity. I have seen where 4nine's have reversed to due heat and if both do it's fine, otherwise I like the idea, one less thing to break possibly.

 

[Robert Cromwell]

The only thing I see and someone may have beat me to it is, if a magnet reverses polarity. I have seen where 4nine's have reversed to due heat and if both do it's fine, otherwise I like the idea, one less thing to break possibly.

And not go to unscrew the atty and have the top unscrew from the base down in there?