New mod and tank

Status
Not open for further replies.

chacas

Full Member
Sep 25, 2014
32
8
Hi all. I finally decided to upgrade from my Kangertech subox mini. Been using it since February and was very pleased with it. But after a while I wanted something new with more power .

Finally I bought the smok Alien with TFV4 mini tank 3 days ago, and it's been great. I have a question on the tank though. I have always rebuild my own coils on the subtank with kenthal wire and Japanese cotton. The TFV4 came with the clapton coil. Can I still rebuild with kenthal or shall I buy some clapton coil?
 

chacas

Full Member
Sep 25, 2014
32
8
I tried to build my RBA on the TFV4 mini.
1st attempt: it was ok at first but then started giving dry hits
2nd attempt: a bit of leakage and dry hit if exceeding 20W which is very low

I used the premade clapton coil that was original installed on the RBA which is reading 0.716 ohms and japanese cotton. Ideally I'd like to go to higher wattage as it's not strong at all on 20W but I'm concerned that I will burn the wick again. Apart from that I cannot figure out why it's leaking.

Any suggestions.
 
  • Like
Reactions: Super Flex

chacas

Full Member
Sep 25, 2014
32
8
Another issue I found is when you need to replace the coil or wick while the tank is not empty. On the subtank I used to just flip it upside down and open from the bottom with out any issues. On the TFV4 mini the only way I found to get to the coil is to remove completely the glass and I didn't find a way to open from the bottom
 
  • Like
Reactions: Super Flex
Status
Not open for further replies.

Users who are viewing this thread