Hey I just bought a new mod and atomizer the Gamma RBA by hcigar and I got it on the silver dragon telescopic mod by sigelei , I have used my favorite coil of 24 gauge kanthal wrapped 9 times on a 1/64th drill bit I get nice clouds on my other build, but not on this one with the exact same build any ideas why? Also it reads one ohm higher on the gamma than my other rda weird. Anyone else have this same gamma RBA any tips?
New mod-need advice
- Thread starter BradMccullin
- Start date
- th_trl_thread_readers 0
- Status
New mod and atomizer (Gamma)
Gamma on Sigelei Silver Dragon mod.
other build. (Build1)
Nice cloulds on Build1.
Gamma reads 1 ohm higher than on Build1.
1 ohm??? A whole ONE ohm?
1/64" drill bit??? Do you mean 1/16"???
I think your resistance is way too high. I have a Quasar and my vents are pretty huge for air flow. but I run 0.19 ohms for my resistance. That is 6 wraps of 24 gauge Kanthal. I don't know how you are getting 0.8 ohms higher, that's not even sub-ohms anymore. I have used everything from 0.18 ohms to 0.42 ohms. Honestly I hate anything above 0.35 ohms. This is just my opinion, I like a little heat and some throat hit. I use 6 mg nicotine strength for my juice.
could be the posts. Sometimes the posts are loose or just bad, or the length of your wire could be different.
That's a massive amount of 24 gage to heat up, will experience vape lag time before it gets up to temp me thinks. Point 0.6-0.7 ohms would be more responsive with wire that thick. Same thing with twisted 28 combos.
well 0.8ohms more with the same number of wraps and diameter sounds like a different gauge of wire.
Woah! Hang on there; have you got the batteries to handle that?
- Status
Similar threads
