New tank settings

[brittany bell]

hey everyone!
Since you guys know way more than I do.... I just got a new uwell crown tank for my Evic mini for now I'm using the coil that came pre installed the dual .25 one. What setting should I have my mod set to for that coil?

 

[RandyF]

What kind of wire, just regular kanthal? Do you lung hit or mouth to lung?

 

[brittany bell]

What kind of wire, just regular kanthal? Do you lung hit or mouth to lung?

Mouth to lung, not sure on the wire in just using what it came pre-installed with

 

[Topwater Elvis]

Be sure to thoroughly prime the new/unused head.
As far as what settings go, the standard evic mini doesn't have a SS temp control mode so use watt mode.
Same as any other delivery device, start off at a low power setting & work your way up until you find what you like.

MTL is gonna be a little finicky using .25Ω and enough airflow to keep from burning the wicking material.
What nic mg/ml are you using?

 

[brittany bell]

I currently have it in the tcr mode but I noticed you can change it to "m1, m2, or m3" and I've never used this setting before so I don't know what the differences are

 

[Topwater Elvis]

Those are tcr memory placeholders where the user can input differing tcr values for differing wire types. You'd have to know what values to enter.

If you have updated the firmware on a standard mini or have a evic vttwo mini, or vtc mini it may or may not recognize the wire type automagically if you select temp control. You'll need to refer to the owners manual or instructions from whichever update has been done.
The .25Ω crown head is supposedly SS wire.

I'm not a temp control fan, I'd use watt mode & adjust power up/down to find what I liked best.

 

[brittany bell]

Those are tcr memory placeholders where the user can input differing tcr values for differing wire types. You'd have to know what values to enter.

If you have updated the firmware on a standard mini or have a evic vttwo mini, or vtc mini it may or may not recognize the wire type automagically if you select temp control. You'll need to refer to the owners manual or instructions from whichever update has been done.
The .25Ω crown head is supposedly SS wire.

I'm not a temp control fan, I'd use watt mode & adjust power up/down to find what I liked best.

Thank you!! I have the latest firmware update

 

[brittany bell]

So just to clarify is best to keep it in temp SS mode?

 

[brittany bell]

Be sure to thoroughly prime the new/unused head.
As far as what settings go, the standard evic mini doesn't have a SS temp control mode so use watt mode.
Same as any other delivery device, start off at a low power setting & work your way up until you find what you like.

MTL is gonna be a little finicky using .25Ω and enough airflow to keep from burning the wicking material.
What nic mg/ml are you using?

6 mg nic

 

[daviedog]

In TC use stainless steel 316.
You may use wattage or even bypass. Nico content & airflow are important considerations also..

 

[brittany bell]

In TC use stainless steel 316.
You may use wattage or even bypass. Nico content & airflow are important considerations also..

Okay thank you. So far I'm liking the SS 316 mode best

 

[Txaggiesaunt]

I would just use it in wattage mode until you learn more about the ins and outs of temp mode, different wires and ohms. Tweet it to yourself for best flavor and hit.

Good luck and VAPE ON

 

[titanle]

I use the crown at 60-80 watts when I have the stock 0.25 coil installed. I find the best flavour around 75-80 watts for .25