Hello again. I'm thinking about getting an Innokin Endura T22 to use at work. Any thoughts?
Also... is it worth getting an ultrasonic cleaner for my equipment?
If I may; an Ultrasonic cleaner has fairly limited uses.
Many moons ago, when anything arrived, I would got to the bother of getting it down from the shelf, filling it with warm water (sometimes a little w'up liquid) but really.... it's too much fuss.
Rinse out new tanks in warm water, sit them in a cup for 10 minutes etc.
Buy one for general use, but it's hardly worth it for e-cig equipment. It doesn't rejuvenate coils and certainly won't 'sonic' the crud off a blackened coil.
T22 is great. Shame about the draw on the tank. I remember the iClear30S (and the original iClear30) and it would be very rare for someone to not want to loosen that draw within a few weeks, new vaper or not. You could try it, but see it as a temporary tank. You could put another tank on the mod with more airflow options, of course. The 1.5ohm Cubis would produce the same 14 watt vape with a looser draw.
Both the "T" series Innokins must run at 4.6v (approx) which makes it a bit of an oddity.