NEW!! Weekly GotVapes Ultimate Contest Prize Giveaway & Chit Chat Hangout Thread, Come and Have Fun!!

Status
Not open for further replies.

barefootntx

Ultra Member
ECF Veteran
Verified Member
Apr 27, 2013
1,375
4,111
jus south a houston, tx, usa
HA! Are you using brass compression bushings on the last one there!??? :D

yes brass compression fittings try and make em a interference fit,but if they are too loose from the polishing stage i just put a thin layer of epoxy on them. the copper one was a copper sleeve used for splicing large wire.
 
Status
Not open for further replies.

Users who are viewing this thread