Newbies Having trouble with AGA-T+

[Zaczero]

Greetings from North Borneo. The Land Below The Wind!!!

I'm using AGA-T+ with Evic. Been using it for a week and the ohm reading is funny. first day is 1.2 ohm, 2nd day increase to 3 ohm, 3rd day increase to 4.2 ohm. Now, it reduce to 3 ohm again. I wonder what's is the problem with my device?

400 mesh
32g ribbon kanthal

I done all the process to set up my AGA-T+ but still same thing happen.

 

[Kanj.nguyen]

Loose contact at negative screw and/ or positive post. Make sure wire is tightly captured there.

A less likely possibiliy is that your coil has snapped.

 

[imnotjp]

yup check it first

 

[Zaczero]

Thank you Sir.

After tighten the negative screw & positive post. it reduce to 2.3 ohm.
What is the resistant recommended? 1.0ohm -1.2ohm or 2.0 ohm 2.8ohm?

 

[gjshaw29]

I like a 1ohm coil on my aga, but the evic won't fire anything lower than 1.2 I believe. For that you'd need to get a mechanical mod.

 

[Red_Bird]

What is the resistant recommended? 1.0ohm -1.2ohm or 2.0 ohm 2.8ohm?

There really is no recommend. It's whatever works/ tastes best for you. Everybody has their own tastes.

 

[Hello World]

What is the resistant recommended? 1.0ohm -1.2ohm or 2.0 ohm 2.8ohm?

Best to keep it at or above 1.5 ohms. Going lower than that and the amp limit of the eVic comes into question.