Nimbus Clone O-Rings

[Just_Pete]

So after receiving my Nimbus Clone from fast tech and cleaning the device, one of the rubber o-rings broke. I tried replacing is with the o-ring from my IGO-L but the o-ring is to thick. Does anyone know the proper dimensions of the IGO-L and Nimbus clone o-rings and where to purchase from?

 

[gchirki]

I had a similar issue. I ordered 16mm o-rings for my igo-w and nimbus clone (not fasttech clone). While the 16mm o-rings work fine for the igo-w, they are too thick for the nimbus. Didn't make much sense to me considering the base of the igo-w is interchangeable with the nimbus. I have some 15mm o-rings on order so if they fit i will let you know. Hoping someone else chimes in on this one.

 

[chambe]

I got 15mm from the o ring store and they aren't fitting on my non-fastech clone. The ones that broke seem to be less than 1mm but I can't find any thinner ones out there. Super ....ty. Luckily I can force the top on still with one of the broken ones.

 

[Cloud Junky]

Give Kidney Puncher a call (Phone: 866-705-5000) they would have them in stock, I get all of my repair bits there. Any of the same diameter o-ring should work but you can get away with 13-17mm that would fit well.

 

[Unforeseen]

Moved from General E-Smoking Discussion to Assorted PV Topics - Rebuildable Atomizer Systems