NOW AVAILABLE! Announcing an Exciting NEW PV @ GotVapes - an eGo Mod the way It SHOULD be and Made by the eGo Masters - Joyetech eGo-T MOD w/ NEW Cont

Status
Not open for further replies.

dannoman

Unregistered Supplier
ECF Veteran
Oct 22, 2010
6,896
12,330
Sugar Land, Texas USA
egotmod.png


egotmod_1.png


egotmod_2.png


egotmod_3.png


egotmod_4.png


egotmod_5.png

Fresh From joyetech and NEW at GotVapes, Introducing:
The Genuine joyetech NEW eGo-T mod with Upgraded Control Head
Complete Kit - Control Head, Tube & Joyetech 18650 2200mah Battery

How would you feel about an eGo mod that takes 18650 batteries in 9 colorful tubes, extremely stylish design and reliable Joyetetch quality?

We're speaking of the perfected and upgraded eGo-T Mod. Lets take a look at the incredible and well thought out feature list:

  • 5-click shut off - YUP, just like Joyetech's regular eGo offerings.
  • SWITCH from unregulated 3.7v (4.2 fully charged) to 3.3-3.4 Regulated - Vape a bit too toasty for you on a fresh battery with those low-ohm FLüXomizers or top-coil Phoenix's...SWITCH to regulated mode!
  • This is our favorite part - if you already have an eGo charging system (500mah recommended for fastest charging) and especially any ego-t, ego-c battery charging system that we sell here at GotVapes - this baby charges, YUP, just like your regular eGo - screw it in to your USB charger and plug to computer's USB or plug into the Joyetech wall adapter and it charges in the tube. You of course can take the battery out and charge it in your present set-up.
  • Each tube comes emblazoned with Joyetech eGo-T Uprade on the side and also has the Joyetech etched endcaps.


How It Works:
  • Press the large comfortable rubber button on the side of the control head with 5 rapid clicks and turn the unit on - A blue backlit LED on the button indicates you are in regulated 3.3v mode, just like a standard Joyetech eGo.
  • PRESS & HOLD the button until the LED changes to an orange back-lit display (this takes about 5 seconds and button will blink 3 times). This indicates you have successfully switched to Unregulated mode, providing, depending on the battery charge, up to 4.2v. The voltage will change with use as with any Unregulated MOD. Go from Unregulated to Regulated in the same fashion.
  • Rapid 5-click (within 1.5 seconds) ON/Off is available in either mode.
  • Charge simply by screwing 510 connection on to your eGo USB charger and charge on either your computer's USB or plug into your wall wart (500mah MegaFast Joyetech carger is recommended, sold here seperately at GotVapes). OR you can unscrew the control head and take the batetry out and slip into your favorite dedicated li-on battery charger.
  • Takes 18650 batteries, you can purchase higher mah batteries and use in your unit. Due to the variances in manufacturing we can't guarantee every 18650 battery will work with this unit so we have supplied a Joyetech branded 18650 battery built for this unit and included in the kit purchase.

What You Receive:

  • BLACK, soft rubberized-feel, battery tube OR Brilliant Flecked Silver
  • Gorgeous brushed steel finish UPGRADED control head
  • Joyetech branded 16850 2200mah battery


Use of batteries other than the Joyetech 2200 18650 or the Sanyo sanctioned 2600mah battery will void the warranty on these. Also cross threading is not covered by our 14-day warranty.


We will also carry almost all colors of tubes available from Joyetech for this and as a seperate purchase: Matte Black, White, Steel, Titanium, Copper, Red, Blue, Green, Pink, Wine. All match up well with the Joyetech Control Head:

colorsjoye.png




Genuine Joyetech NEW eGo-T MOD : GotVapes.com, E-cigarette Supplies - Atomizers Cartomizers Mods Juice and more
 
Last edited:

dannoman

Unregistered Supplier
ECF Veteran
Oct 22, 2010
6,896
12,330
Sugar Land, Texas USA
From what I understand they upgraded the control units in these just in past several weeks to allow sort of a dual voltage situation, regulated and unregulated and I think that is VERY practical to vapers who are satisfied with the eGo form factor...when they first came out we were carrying the ePower and were happy with that but then their heads went completely south and we dropped them after almost a year (we were one of the very first vendors in USA to carry the ePower, besides MadVapes). We decided to pay another visit to these. I love the idea of a Mod that you don't necessarily have to remove batteries and slip into a Trustfire and some such, just for convenience sake when you don't feel like messing with tracking down your batteries, etc...not to mention the poor quality of some of the stock chargers that come with the kits. Many causal users love the eGo form factor, the contained battery, and don't necessarily have li-on chargers (but do have a good solid eGo charger), but also can see the benefit of replaceable batteries...this will really appeal to them with the solid reliablity of Joyetech's QC.
 
Last edited:

rse1

Senior Member
ECF Veteran
Verified Member
Feb 5, 2012
202
59
Aloha, OR USA (near portland)
MastiffMike - I have two, really like them, and they have a flat bottom (they are pretty stable standing on end). They are a little heavy for shirt-pocket carry and one needs to be careful with the aluminum threads (especially with button top 18650 batteries). It is nice to be able to switch to unregulated if you want a warmer vape with a fresh battery. I use either 3000 mah Ultrafire or Panasonic 2250 mah hybrids and either lasts a full day or more of heavy vaping.
 

Briar

Ultra Member
ECF Veteran
Jul 28, 2009
2,350
2,558
64
A fool on the hill in Deposit, NY
An off the wall question: Can these use a Kick? I know it'd physically fit, but would the Kick's circuitry cause problems for the circuitry built into this unit?...

Now, if I could Kick it, I'd seriously consider getting it - so I add my question to Mastiff's... Anyone know?
 

dannoman

Unregistered Supplier
ECF Veteran
Oct 22, 2010
6,896
12,330
Sugar Land, Texas USA
HI Mike--yes flat--that would be so FLAWED otherwise : ) - I don't think JOyetech would short circuit like that in their thinking...

An off the wall question: Can these use a Kick? I know it'd physically fit, but would the Kick's circuitry cause problems for the circuitry built into this unit?

Another question, it's hard to tell from the pic but is the bottom flat? It almost looks rounded (i.e. can't stand it up on it's end).
 

dannoman

Unregistered Supplier
ECF Veteran
Oct 22, 2010
6,896
12,330
Sugar Land, Texas USA
As far as kicking it with this baby (haha) ... Not sure as the control head has a PCB, and not sure if I would want to mess KICKing its head (again haha)...If you are in unregulated mode with this, it may be possible? Dunno...will try to get some info cus Mike I saw you like kicking things (please never take it out on the dog though--he has become our mascot)
 

dannoman

Unregistered Supplier
ECF Veteran
Oct 22, 2010
6,896
12,330
Sugar Land, Texas USA
egotmod.png


egotmod_1.png


egotmod_2.png


egotmod_3.png


egotmod_4.png


egotmod_5.png

Fresh From Joyetech and NEW at GotVapes, Introducing:
The Genuine Joyetech NEW eGo-T MOD with Upgraded Control Head
Complete Kit - Control Head, Tube & Joyetech 18650 2200mah Battery

How would you feel about an eGo mod that takes 18650 batteries in 9 colorful tubes, extremely stylish design and reliable Joyetetch quality?

We're speaking of the perfected and upgraded eGo-T Mod. Lets take a look at the incredible and well thought out feature list:


  • 5-click shut off - YUP, just like Joyetech's regular eGo offerings.
  • SWITCH from unregulated 3.7v (4.2 fully charged) to 3.3-3.4 Regulated - Vape a bit too toasty for you on a fresh battery with those low-ohm FLüXomizers or top-coil Phoenix's...SWITCH to regulated mode!
  • This is our favorite part - if you already have an eGo charging system (500mah recommended for fastest charging) and especially any ego-t, ego-c battery charging system that we sell here at GotVapes - this baby charges, YUP, just like your regular eGo - screw it in to your USB charger and plug to computer's USB or plug into the Joyetech wall adapter and it charges in the tube. You of course can take the battery out and charge it in your present set-up.
  • Each tube comes emblazoned with Joyetech eGo-T Uprade on the side and also has the Joyetech etched endcaps.


How It Works:

  • Press the large comfortable rubber button on the side of the control head with 5 rapid clicks and turn the unit on - A blue backlit LED on the button indicates you are in regulated 3.3v mode, just like a standard Joyetech eGo.
  • PRESS & HOLD the button until the LED changes to an orange back-lit display (this takes about 5 seconds and button will blink 3 times). This indicates you have successfully switched to Unregulated mode, providing, depending on the battery charge, up to 4.2v. The voltage will change with use as with any Unregulated MOD. Go from Unregulated to Regulated in the same fashion.
  • Rapid 5-click (within 1.5 seconds) ON/Off is available in either mode.
  • Charge simply by screwing 510 connection on to your eGo USB charger and charge on either your computer's USB or plug into your wall wart (500mah MegaFast Joyetech carger is recommended, sold here seperately at GotVapes). OR you can unscrew the control head and take the batetry out and slip into your favorite dedicated li-on battery charger.
  • Takes 18650 batteries, you can purchase higher mah batteries and use in your unit. Due to the variances in manufacturing we can't guarantee every 18650 battery will work with this unit so we have supplied a Joyetech branded 18650 battery built for this unit and included in the kit purchase.


What You Receive:


  • BLACK, soft rubberized-feel, battery tube OR Brilliant Flecked Silver
  • Gorgeous brushed steel finish UPGRADED control head
  • Joyetech branded 16850 2200mah battery


Use of batteries other than the Joyetech 2200 18650 or the Sanyo sanctioned 2600mah battery will void the warranty on these. Also cross threading is not covered by our 14-day warranty.


We will also carry almost all colors of tubes available from Joyetech for this and as a seperate purchase: Matte Black, White, Steel, Titanium, Copper, Red, Blue, Green, Pink, Wine. All match up well with the Joyetech Control Head:
colorsjoye.png


Genuine Joyetech NEW eGo-T MOD : GotVapes.com, E-cigarette Supplies - Atomizers Cartomizers Mods Juice and more
 

ZebadeeDoodah

Senior Member
ECF Veteran
Jul 21, 2011
160
74
Tucson, AZ USA
[*]PRESS & HOLD the button until the LED changes to an orange back-lit display (this takes about 5 seconds and button will blink 3 times). This indicates you have successfully switched to Unregulated mode, providing, depending on the battery charge, up to 4.2v. The voltage will change with use as with any Unregulated MOD. Go from Unregulated to Regulated in the same fashion.

I'm confused by this. Isn't "Press and Hold" how you vape? What keeps it from switching modes every time you vape it?
 
Status
Not open for further replies.

Users who are viewing this thread