Stumbled on an old Odin V2 review, it said the atty could be set up for single coil, if I built a single 1ohm coil, 28g, how would it vape. I vape unflavoured juice so not worried about the flavor side of things.
Odin
- Thread starter Danrogers
- Start date
- th_trl_thread_readers 0
- Status
It would vape just fine, but I'm not sure what advantage over, say, an RM2 that would represent.
The Odin shines with more air and some beefier, lower ohm coils - it can be a real vapour factory. It can be dialled back, sure, though. Less flavour than an RM2, but that's a moot point in your case, and it would give you some head room on the air to maybe experiment with more, but given you're a MTL'er, you likely won't want to really open it up.
The Odin shines with more air and some beefier, lower ohm coils - it can be a real vapour factory. It can be dialled back, sure, though. Less flavour than an RM2, but that's a moot point in your case, and it would give you some head room on the air to maybe experiment with more, but given you're a MTL'er, you likely won't want to really open it up.
I vape my Odin strictly single coil! Usually at a 1.2 ohm coil (28gauge 2mm diameter 7wraps). In single coil mode it's a Tootle Puffers dream! As is The Nuppin, and don't let anyone tell you different!
Sent from my Commodore 64 using Tapatalk
Sent from my Commodore 64 using Tapatalk
Larger the atty the cooler it will run.. do if ya like it warm thrn one would want to run low ohms on it.
Runing a 1 ohm on a small 14mm atty or derringer (cause its short so small volume) will be warm compared to a larger atty.
I've done the dance with larger attys and built a cyclone/rm2 for the wifes mini reo and thought.. hmm. Since then I'm back to small attys.
Runing a 1 ohm on a small 14mm atty or derringer (cause its short so small volume) will be warm compared to a larger atty.
I've done the dance with larger attys and built a cyclone/rm2 for the wifes mini reo and thought.. hmm. Since then I'm back to small attys.
Odin is a stellar device anyway you use it. It would be hard to really do anything wrong with it
I've been using Odin's (V1's) for months now and just recently, for the first time, built one with a single coil around .9 ish and it was pretty darn good. I usually do duals around .5. I was very pleasantly surprised the vapor was as good as it was and the flavor wasn't to shabby either.
I like the Odin with a single 30 or 29 gage coil. They do run a little cooler than the RM2 like Papa said, but I prefer a cooler vape. One benefit for me is when the battery starts to get a little low, I can restrict the airflow a tad and let the vapor build up in the attie, extending my run time a bit. And with a fresh battery I can open it up and let it rip. Yeah, at 1.4Ω-1.6Ω LOL.
I gotta say, I think my favorite attie is the Igo-W, pretty good bang for the buck, and the IGO-l was my first dripper attie, so I just have a soft spot for that one. I like the single coil cap drilled out a bit, not even sure anymore how much, I just keep using the same drill bit every time I pick one up
The biggest sell point on the Odin's for me was the build quality! Those things are built like a brick $#(+ house!
I gotta say, I think my favorite attie is the Igo-W, pretty good bang for the buck, and the IGO-l was my first dripper attie, so I just have a soft spot for that one. I like the single coil cap drilled out a bit, not even sure anymore how much, I just keep using the same drill bit every time I pick one up
The biggest sell point on the Odin's for me was the build quality! Those things are built like a brick $#(+ house!
Last edited:
Speaking of Odins (sorry for the detour)... I dragged my feet and missed the summer10 coupon code. Anyone aware of any active codes? I certainly don't mind paying full retail if necessary but every little bit helps.
I prefer the V1's, That Kawasaki green looks awesome!
Thank you. It is the coolest looking atomizer I've ever owned.
- Status
